BS EN ISO 12215-5 - SMALL CRAFT - HULL CONSTRUCTION AND SCANTLINGS - PART 5: DESIGN PRESSURES FOR MONOHULLS, DESIGN STRESSES, SCANTLINGS DETERMINATION

Available format(s)

Hardcopy , PDF

Language(s)

English

Publisher

British Standards Institution

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 General requirements
6 Main dimensions, data and areas
7 Dimensions of panels and stiffeners
8 Pressure adjusting factors
9 Design pressures
10 Mechanical properties and design stresses
11 Analysis methods
Annex A (normative) - Application of methods of
        analysis 1 to 3 of Table
Annex B (normative) - Mechanical properties of metals
Annex C (normative) - FRP laminates properties and
        calculations
Annex D (normative) - Drop test for craft < 6 m
Annex E (normative) - Sandwich calculations
Annex F (normative) - Wood/plywood laminate properties
        and calculations
Annex G (normative) - Geometric properties of stiffeners
Annex H (normative) - Laminate stack analysis for plating
        and stiffeners
Annex I (informative) - Recommended minimum thickness
Annex J (normative) - Workboats
Annex K (informative) - Loads induced by outboard engines
Annex L (informative) - Checking sheet for data needed
        according to assessment method
Bibliography

BS EN ISO 12215-5.

Committee	GME/33
DocumentType	Draft
Pages	128
PublisherName	British Standards Institution
Status	NA

ISO 1922:2012	Rigid cellular plastics Determination of shear strength
ISO 845:2006	Cellular plastics and rubbers Determination of apparent density
BS EN 408 : 2010	TIMBER STRUCTURES - STRUCTURAL TIMBER AND GLUED LAMINATED TIMBER - DETERMINATION OF SOME PHYSICAL AND MECHANICAL PROPERTIES
ASTM C 393 : 2000	Standard Test Method for Flexural Properties of Sandwich Constructions
ISO 8666:2016	Small craft Principal data
ISO 527-2:2012	Plastics — Determination of tensile properties — Part 2: Test conditions for moulding and extrusion plastics
ISO 12216:2002	Small craft Windows, portlights, hatches, deadlights and doors Strength and watertightness requirements
ISO 178:2010	Plastics Determination of flexural properties
ISO 844:2014	Rigid cellular plastics Determination of compression properties
BS EN 1995-1-1 : 2012	EUROCODE 5: DESIGN OF TIMBER STRUCTURES - PART 1-1: GENERAL - COMMON RULES AND RULES FOR BUILDINGS
ISO 527-1:2012	Plastics Determination of tensile properties Part 1: General principles