ANSI INCITS 431 : 2007

Foreword
Introduction
1 Scope
2 References
   2.1 Normative references
   2.2 Approved references
   2.3 References under development
   2.4 Other references
3 Definitions, symbols, abbreviations, and conventions
   3.1 Definitions
   3.2 Symbols and abbreviations
   3.3 Keywords
   3.4 SAT specific terminology
   3.5 Conventions
4 General
5 SCSI architectural elements
   5.1 Overview
   5.2 Unit attention condition
   5.3 Handling errors in ATA commands
   5.4 ATA nexus loss
   5.5 ATA hardware and software reset processing
6 Task management model
   6.1 Overview
   6.2 Queued commands
   6.3 Task management functions
   6.4 Control Byte
   6.5 I_T nexus loss
7 Summary of SCSI/ATA command mappings
   7.1 Translated and emulated commands
8 SCSI Primary Commands (SPC) mapping
   8.1 INQUIRY command
   8.2 LOG SENSE command
   8.3 MODE SELECT (6) command
   8.4 MODE SELECT (10) command
   8.5 MODE SENSE (6) command
   8.6 MODE SENSE (10) command
   8.7 READ BUFFER command
   8.8 REQUEST SENSE command
   8.9 SEND DIAGNOSTIC command
   8.10 TEST UNIT READY command
   8.11 WRITE BUFFER command
9 SCSI Block Commands (SBC) mapping
   9.1 Translating LBA and transfer length and ATA command
        use constraints
   9.2 FORMAT UNIT command
   9.3 READ commands overview
   9.4 READ (6) command
   9.5 READ (10) command
   9.6 READ (12) command
   9.7 READ (16) command
   9.8 READ CAPACITY (10) command
   9.9 READ CAPACITY (16) command
   9.10 REASSIGN BLOCKS command
   9.11 START STOP UNIT command
   9.12 SYNCHRONIZE CACHE (10) command
   9.13 SYNCHRONIZE CACHE (16) command
   9.14 VERIFY (10) command
   9.15 VERIFY (12) command
   9.16 VERIFY (16) command
   9.17 WRITE commands overview
   9.18 WRITE (6) command
   9.19 WRITE (10) command
   9.20 WRITE (12) command
   9.21 WRITE (16) command
   9.22 WRITE AND VERIFY commands overview
   9.23 WRITE AND VERIFY (10) command
   9.24 WRITE AND VERIFY (12) command
   9.25 WRITE AND VERIFY (16) command
   9.26 WRITE SAME (10) command
   9.27 WRITE SAME (16) command
10 Parameters for SAT implementations
   10.1 Mode parameters
   10.2 Log pages
   10.3 Vital product data parameters
11 Error and sense reporting
   11.1 Error translation - ATA device error to SCSI error map
12 SAT-specific SCSI extensions
   12.1 SAT-specific SCSI extensions overview
   12.2 ATA PASS-THROUGH commands
   12.3 SAT-specific mode pages
   12.4 SAT-specific VPD pages
Annex
A INQUIRY command translation for ATAPI devices
      A.1 INQUIRY command overview
      A.2 Supported VPD Pages VPD page
      A.3 ATA Information VPD page