This method sets out a rapid method for determining compaction control parameters for soils. The method involves relating converted wet density (CWD) of the laboratory-compacted soil to added moisture (Z) without the need to determine moisture content.The test is based on standard compactive effort in accordance with AS 1289.5.1.1. If modified compactive effort in accordance with AS 1289.5.2.1 is used, experimental data must initially be accumulated for that particular soil in order that the moisture variation can be reliably assessed (see Note 1).Because it is rapid method, minor differences between results obtained by this rapid procedure and the results obtained by the method of compaction control given in AS 1289.5.4.1 may occur.The procedure is applicable to that portion of soil which passes a 37.5 mm sieve. Corrections for up to 20% oversize material can be made to values determined by this method. Soil which all passes a 19.0 mm sieve is compacted in a 105 mm diameter mould. Soil which contains more than 20% of material retained on a 19.0 mm sieve is compacted in a 152 mm diameter mould.Because of the omission of proper curing, the method might not be reliable for soils that are much wetter or dryer than the optimum moisture content.Further, because of the empirical basis for the calculation of moisture variation, the method is limited to added moisture values (Z) between - 4% and + 6% (see Figure 1). The method may be used for checking material before placement to ensure that the moisture content is within specified limits (see Note 2).

First published as AS A89.21-1973.Revised and redesignated AS 1289.E7.1-1977.Second edition 1983.Revised and redesignated AS 1289.5.7.1-1993. First published as AS A89.21-1973. Revised and redesignated AS 1289.E7.1-1977. Second edition 1983. Revised and redesignated AS 1289.5.7.1-1993.