AS 4367-1996

1 - AS 4367-1996 RADIOCOMMUNICATIONS EQUIPMENT USED IN THE INSHORE BOATING RADIO SERVICES BAND
4 - PREFACE
4 - CONTENTS
5 - 1 SCOPE
5 - 2 DEFINITIONS
5 - 2.1 A3E
5 - 2.2 ALC threshold
5 - 2.3 Battery-end-of-life voltage
5 - 2.4 Channel
5 - 2.5 Emission
5 - 2.6 Handheld station
5 - 2.7 J3E
5 - 2.8 Limited coast station
5 - 2.9 Necessary bandwidth
5 - 2.10 Out-of-band emission
5 - 2.11 Peak envelope power (PEP)
5 - 2.12 Radiation
6 - 2.13 Ship station
6 - 2.14 SINAD ratio
6 - 2.15 Spurious emission
6 - 2.16 Station
6 - 2.17 Unwanted emission
6 - 3 TEST CONDITIONS
6 - 3.1 Application
6 - 3.2 Normal test conditions
6 - 3.2.1 Temperature
6 - 3.2.2 Voltage
6 - 3.3 Extreme test conditions
6 - 3.3.1 Temperatures
6 - 3.3.2 Voltage
6 - 3.4 Nominal test frequency
6 - 3.5 Rated peak envelope power (J3E mode)
6 - 3.6 Reference audio frequency output power
6 - 3.7 Reference sensitivity
6 - 3.8 Reference sideband power
7 - 3.9 Standard modulating signal (A3E mode)
7 - 3.10 Standard modulating signal (J3E mode)
7 - 3.11 Standard SINAD ratio
7 - 3.12 Standard input signal (A3E)
7 - 3.13 Standard input signal (J3E)
7 - 4 GENERAL REQUIREMENTS
7 - 4.1 Equipment markings
7 - 4.2 Adjustment mechanism
7 - 4.3 Protective design
7 - 4.4 Channel operation
7 - 4.5 Mandatory distress channels
8 - 5 TRANSMITTER REQUIREMENTS
8 - 5.1 Emission
8 - 5.1.1 Modes
8 - 5.1.2 Content
8 - 5.2 Nominal carrier frequency
8 - 5.3 Frequency error
8 - 5.3.1 Limit
8 - 5.3.2 Method of test
8 - 5.4 Transmission during channel change (A3E mode)
8 - 5.4.1 Limit
8 - 5.4.2 Method of test
8 - 5.5 Carrier power (A3E mode)
8 - 5.5.1 Limit
8 - 5.5.2 Method of test
9 - 5.6 Rated peak envelope power (J3E mode)
9 - 5.6.1 Limit
9 - 5.6.2 Method of test
9 - 5.7 Modulation limiting
9 - 5.7.1 Limit
9 - 5.7.2 Method of test
9 - 5.8 Modulation sensitivity
9 - 5.8.1 Limit
9 - 5.8.2 Method of test
9 - 5.9 Automatic level control
9 - 5.9.1 Limit
9 - 5.9.2 Method of test
9 - 5.10 Out-of-band emission suppression (A3E mode)
9 - 5.10.1 Limit
10 - 5.10.2 Method of test
10 - 5.11 Spurious emissions (A3E mode)
10 - 5.11.1 Limit
10 - 5.11.2 Method of test
10 - 5.12 Unwanted emission suppression (J3E mode)
10 - 5.12.1 Limits
10 - 5.12.2 Method of test
10 - 6 RECEIVER REQUIREMENTS
10 - 6.1 Receiver modes
11 - 6.2 Reference sensitivity
11 - 6.2.1 Limit
11 - 6.2.2 Method of test
11 - 6.3 Maximum squelch level
11 - 6.3.1 Limit
11 - 6.3.2 Method of test
11 - 6.4 Adjacent channel selectivity
11 - 6.4.1 A3E mode
11 - 6.4.2 J3E mode
12 - 6.5 Spurious response immunity
12 - 6.5.1 Limit
12 - 6.5.2 Methods of test
12 - 6.6 Conducted spurious radiation
12 - 6.6.1 Limit
12 - 6.6.2 Method of test
12 - 6.7 Rated audio frequency output power
12 - 6.7.1 Limit
13 - 6.7.2 Method of test