PREFACEINTRODUCTION1 Scope2 Normative references3 Terms and definitions4 Method A - Production of a standardized 500 W nominal test flame based on existing hardware 4.1 Requirements 4.2 Apparatus and fuel 4.2.1 Burner 4.2.2 Flowmeter 4.2.3 Manometer 4.2.4 Control valve 4.2.5 Copper block 4.2.6 Thermocouple 4.2.7 Temperature/time indicating/recording and timing devices 4.2.8 Fuel gas 4.2.9 Laboratory fumehood/chamber 4.3 Production of test flame 4.4 Confirmation of the test flame 4.4.1 Principle 4.4.2 Procedure 4.4.3 Verification5 Method B6 Method C - Production of a standardized 500 W nominal test flame based on nonadjustable hardware 6.1 Requirements 6.2 Apparatus and fuel 6.2.1 Burner 6.2.2 Flowmeters 6.2.3 Manometer 6.2.4 Control valves 6.2.5 Copper block 6.2.6 Thermocouple 6.2.7 Temperature/time indicating/recording and timing devices 6.2.8 Fuel gas 6.2.9 Air supply 6.2.10 Laboratory fumehood/chamber 6.3 Production of test flame 6.4 Confirmation of the test flame 6.4.1 Principle 6.4.2 Procedure 6.4.3 Verification7 Method D8 Classification and designationAnnex A (informative) - Test method A arrangementAnnex B (withdrawn)Annex C (normative) - Test method C arrangementAnnex D (withdrawn)Annex E (informative) - Recommended arrangements for the use of the test flamesAnnex F (informative) - Test arrangements for tests on equipmentAnnex G (informative) - Test arrangements for tests on materialAnnex H (informative) - Access to equipment manufacturers and suppliersBibliography