ASTM B 570 : 2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Specification for Copper-Beryllium Alloy (UNS Nos. C17000 and C17200) Forgings and Extrusions
Hardcopy , PDF
11-05-2022
English
11-16-2016
1.1This specification establishes the requirements for copper-beryllium alloy forgings and extrusions produced from the following alloys.
| Copper Alloy UNS No. | Nominal % Composition |
| C17000 | 1.7 |
Note 1:Requirements for copper-beryllium alloy rod and bar appear in Specification B196/B196M (Section 2).
1.2Unless otherwise specified, Copper Alloy UNS No. C17200 shall be the alloy furnished whenever Specification B570 is specified without any alloy designation.
1.3Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units which are provided for information only and are not considered standard.
1.4The following safety hazard caveat pertains only to the test method(s) described in this specification:
1.4.1This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.