Standard Test Method for Tensile Strength of Concrete Surfaces and the Bond Strength or Tensile Strength of Concrete Repair and Overlay Materials by Direct Tension (Pull-off Method)

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

05-01-2020

Publisher

American Society for Testing and Materials

1.1This test method is suitable for both field and laboratory use to determine one or more of the following:

1.1.1The near-surface tensile strength of the substrate as an indicator of the adequacy of surface preparation before application of a repair or overlay material.

1.1.2The bond strength of a repair or an overlay material to the substrate.

1.1.3The tensile strength of a repair or overlay material, or an adhesive used in repairs, after the material has been applied to a surface.

1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3The text of this standard refers to notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	C 09
DocumentType	Test Method
Pages	5
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM C 1583/C1583M : 2013

ACI SPEC-548.10:2022

Type Methyl Methacrylate Slurry (MMS) Polymer Overlays for Bridge and Parking Garage Deck— Specification

ASTM C 125 : 2021	Standard Terminology Relating to Concrete and Concrete Aggregates
ASTM C 125 : 2000	Standard Terminology Relating to Concrete and Concrete Aggregates
ASTM C 900 : 2023	Standard Test Method for Pullout Strength of Hardened Concrete
ASTM C 125 : 2021 : REV A	Standard Terminology Relating to Concrete and Concrete Aggregates
ASTM C 125 : 2020	Standard Terminology Relating to Concrete and Concrete Aggregates
ASTM C 900 : 2019	Standard Test Method for Pullout Strength of Hardened Concrete
ASTM C 125 : 2009	Standard Terminology Relating to Concrete and Concrete Aggregates