• There are no items in your cart

ASTM D 5173 : 2015

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Guide for On-Line Monitoring of Total Organic Carbon in Water by Oxidation and Detection of Resulting Carbon Dioxide
Available format(s)

Hardcopy , PDF

Superseded date

04-24-2023

Language(s)

English

Published date

04-27-2015

This guide covers the selection, establishment, and application of monitoring systems for carbon and carbon compounds by on-line, automatic analysis, and recording or otherwise signaling of output data

1.1This guide covers the selection, establishment, and application of monitoring systems for carbon and carbon compounds by on-line, automatic analysis, and recording or otherwise signaling of output data. The system chosen will depend on the purpose for which it is intended (for example, regulatory compliance, process monitoring, or to alert the user to adverse trends) and on the type of water to be monitored (low purity or high purity, with or without suspended particulates, purgeable organics, or inorganic carbon). If it is to be used for regulatory compliance, the test method published or referenced in the regulations should be used in conjunction with this guide and other ASTM test methods. This guide covers carbon concentrations of 0.05 µg/L to 50 000 mg/L. Low end sensitivity and quantitative results may vary among instruments. This guide covers the on-line measurement techniques listed in Table 1. Additional laboratory test methods are available: Test Methods D4129, D4839, D5904, D6317, and D7573.

(A)Consult manufacturer for specific range of measurement.

1.2The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 9.

Committee
D 19
DocumentType
Guide
Pages
8
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

ASTM D 8361 : 2020 Standard Test Method for Total Organic Carbon in Water by Two Stage Wet Chemical Catalyzed Hydroxyl Radical Oxidation with Infra-Red Detection of Resulting Carbon Dioxide
ASTM D 5906 : 2021 Standard Guide for Measuring Horizontal Positioning During Measurements of Surface Water Depths
ASTM D 5127 : 2013 : R2018 Standard Guide for Ultra-Pure Water Used in the Electronics and Semiconductor Industries
ASTM D 6908 : 2006 : R2017 Standard Practice for Integrity Testing of Water Filtration Membrane Systems
ASTM D 5906 : 2002 : R2013 Standard Guide for Measuring Horizontal Positioning During Measurements of Surface Water Depths
ASTM D 5196 : 2006 : R2018 Standard Guide for Bio-Applications Grade Water
ASTM D 1193 : 2006 : R2018 Standard Specification for Reagent Water
ASTM E 2656 : 2016 Standard Practice for Real-time Release Testing of Pharmaceutical Water for the Total Organic Carbon Attribute

ASTM D 5904 : 2002 Standard Test Method for Total Carbon, Inorganic Carbon, and Organic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 7573 : 2009 Standard Test Method for Total Carbon and Organic Carbon in Water by High Temperature Catalytic Combustion and Infrared Detection
ASTM D 3694 : 1996 : R2011 Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents
ASTM D 6317 : 1998 : R2004 Standard Test Method for Low Level Determination of Total Carbon, Inorganic Carbon and Organic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 3370 : 1995 : REV A : R2003 : EDT 1 Standard Practices for Sampling Water from Closed Conduits
ASTM D 1129 : 2003 Standard Terminology Relating to Water
ASTM D 3864 : 2006 Standard Guide for Continual On-Line Monitoring Systems for Water Analysis
ASTM D 7573 : 2009 : R2017 Standard Test Method for Total Carbon and Organic Carbon in Water by High Temperature Catalytic Combustion and Infrared Detection
ASTM D 7573 : 2018 : REV A Standard Test Method for Total Carbon and Organic Carbon in Water by High Temperature Catalytic Combustion and Infrared Detection
ASTM D 1129 : 2013 Standard Terminology Relating to Water
ASTM D 1129 : 2013 : R2020 Standard Terminology Relating to Water
ASTM D 3694 : 1996 Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents
ASTM D 2777 : 2012 Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
ASTM D 6317 : 1998 : R2009 Standard Test Method for Low Level Determination of Total Carbon, Inorganic Carbon and Organic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 5904 : 1996 Standard Test Method for Total Carbon, Inorganic Carbon, and Organic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 5997 : 1996 : R2009 Standard Test Method for On-Line Monitoring of Total Carbon, Inorganic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 1193 : 1977 : R1983 : EDT 1 Standard Specification for Reagent Water
ASTM D 5997 : 2015 Standard Test Method for On-Line Monitoring of Total Carbon, Inorganic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 5904 : 2002 : R2017 Standard Test Method for Total Carbon, Inorganic Carbon, and Organic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 1129 : 2006 Standard Terminology Relating to Water
ASTM D 5997 : 1996 : R2000 Standard Test Method for On-Line Monitoring of Total Carbon, Inorganic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 4453 : 2002 Standard Practice for Handling of Ultra-Pure Water Samples
ASTM D 5997 : 1996 : R2005 Standard Test Method for On-Line Monitoring of Total Carbon, Inorganic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 2777 : 2003 Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water
ASTM D 2777 : 2021 Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
ASTM D 3370 : 2010 Standard Practices for Sampling Water from Closed Conduits
ASTM D 2777 : 2013 Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
ASTM D 4839 : 1994 Standard Test Method for Total Carbon and Organic Carbon in Water by Ultraviolet, or Persulfate Oxidation, or Both, and Infrared Detection
ASTM D 2777 : 1998 Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water
ASTM D 3694 : 1996 : R2017 Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents
ASTM D 1129 : 2013 : R2020 : EDT 1 Standard Terminology Relating to Water
ASTM D 3370 : 2008 Standard Practices for Sampling Water from Closed Conduits
ASTM D 1129 : 1999 : REV A Standard Terminology Relating to Water
ASTM D 4129 : 1998 Standard Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection
ASTM D 6317 : 2015 Standard Test Method for Low Level Determination of Total Carbon, Inorganic Carbon and Organic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 1129 : 2006 : REV A Standard Terminology Relating to Water
ASTM D 1193 : 2006 : R2011 Standard Specification for Reagent Water
ASTM D 7573 : 2018 Standard Test Method for Total Carbon and Organic Carbon in Water by High Temperature Catalytic Combustion and Infrared Detection
ASTM D 1129 : 2003 : REV A Standard Terminology Relating to Water
ASTM D 3694 : 1996 : R2004 Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents
ASTM D 1129 : 2002 Standard Terminology Relating to Water
ASTM D 4453 : 1991 : R1997 Standard Practice for Handling of Ultra-Pure Water Samples
ASTM D 4129 : 2005 : R2012 Standard Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection
ASTM D 1193 : 1991 Standard Specification for Reagent Water
ASTM D 7573 : 2018 : REV A : EDT 1 Standard Test Method for Total Carbon and Organic Carbon in Water by High Temperature Catalytic Combustion and Infrared Detection
ASTM D 4129 : 2005 : R2013 Standard Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection
ASTM D 1129 : 2004 Standard Terminology Relating to Water
ASTM D 2777 : 2008 Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
ASTM D 2777 : 2006 Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
ASTM D 4839 : 2003 : R2017 Standard Test Method for Total Carbon and Organic Carbon in Water by Ultraviolet, or Persulfate Oxidation, or Both, and Infrared Detection
ASTM D 3370 : 2018 Standard Practices for Sampling Water from Flowing Process Streams
ASTM D 1129 : 2002 : REV A Standard Terminology Relating to Water
ASTM D 5904 : 2002 : R2009 Standard Test Method for Total Carbon, Inorganic Carbon, and Organic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 3370 : 1976 Standard Practices for Sampling Water
ASTM D 4129 : 2005 : R2020 Standard Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection
ASTM D 4453 : 2017 Standard Practice for Handling of High Purity Water Samples
ASTM D 3864 : 2012 Standard Guide for On-Line Monitoring Systems for Water Analysis
ASTM D 1193 : 1970 Standard Specification For Reagent Water
ASTM D 1193 : 2006 Standard Specification for Reagent Water
ASTM D 3370 : 1995 : REV A : R1999 : EDT 1 Standard Practices for Sampling Water from Closed Conduits
ASTM D 4453 : 2002 : R2006 Standard Practice for Handling of Ultra-Pure Water Samples
ASTM D 1193 : 1999 Standard Specification for Reagent Water
ASTM D 1129 : 2010 Standard Terminology Relating to Water
ASTM D 4453 : 2011 Standard Practice for Handling of High Purity Water Samples
ASTM D 4839 : 2003 Standard Test Method for Total Carbon and Organic Carbon in Water by Ultraviolet, or Persulfate Oxidation, or Both, and Infrared Detection
ASTM D 3370 : 2007 Standard Practices for Sampling Water from Closed Conduits
ASTM D 4129 : 2005 Standard Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection
ASTM D 1129 : 2006 : REV A : EDT 1 Standard Terminology Relating to Water
ASTM D 1129 : 2001 Standard Terminology Relating to Water
ASTM D 1129 : 2004 : EDT 1 Standard Terminology Relating to Water
ASTM D 1193 : 2006 : R2018 Standard Specification for Reagent Water
ASTM D 2777 : 2008 : EDT 1 Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
ASTM D 3864 : 1996 : R2000 Standard Guide for Continual On-Line Monitoring Systems for Water Analysis
ASTM D 6317 : 1998 Standard Test Method for Low Level Determination of Total Carbon, Inorganic Carbon and Organic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection
ASTM D 4839 : 2003 : R2011 Standard Test Method for Total Carbon and Organic Carbon in Water by Ultraviolet, or Persulfate Oxidation, or Both, and Infrared Detection
ASTM D 4453 : 2016 Standard Practice for Handling of High Purity Water Samples

View more information
US$75.00
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.