• There are no items in your cart

ASTM D 5286 : 2001 : R2005

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Test Methods for Determination of Transfer Efficiency Under General Production Conditions for Spray Application of Paints
Available format(s)

Hardcopy , PDF

Superseded date

11-11-2014

Language(s)

English

Published date

05-15-2005

CONTAINED IN VOL. 06.02, 2017 Defines the determination of the transfer efficiency of spray-applied coatings under general plant conditions.

1.1 These test methods cover the determination of the transfer efficiency of spray-applied coatings under general plant conditions. Transfer efficiency is the ratio of paint solids deposited to the total paint solids used during the application process, expressed as a percent.

1.2 The transfer efficiency is calculated from the weight or volume of the paint solids sprayed and that of the paint solids deposited on the painted part.

1.3 Limitations include the ability to accurately determine the amount of paint solids deposited on the part and the capability of accurate measurement of the amount of paint sprayed.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

Note 1—These test methods apply to general plant production equipment and procedures. A method specific to automotive plants is defined in Test Method D 5066.

Note 2—The relationship between volatile organic compound emission rates and transfer efficiency in automobile and light duty truck topcoat operations, EPA 450/3-88-018, referenced in Test Method D 5066 does not apply to general production facilities.

Note 3—A single-point transfer efficiency measurement may not represent the entire process.

Note 4—The operator and the spray-application equipment-operating conditions during the transfer efficiency measurement should be representative of normal operating conditions.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Section 7, and 10.3.1.

Note 5—These test methods have not been adopted by federal regulatory agencies for demonstration of compliance with air pollution regulations such as VOC, HAPS, etc.

Committee
D 01
DocumentType
Test Method
Pages
5
ProductNote
Reconfirmed 2005
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

ASTM D 6577 : 2015 Standard Guide for Testing Industrial Protective Coatings

ASTM D 1400 : 2000 Standard Test Method for Nondestructive Measurement of Dry Film Thickness of Nonconductive Coatings Applied to a Nonferrous Metal Base (Withdrawn 2006)
ASTM D 1200 : 2010 Standard Test Method for Viscosity by Ford Viscosity Cup
NFPA 33 : 2016 SPRAY APPLICATION USING FLAMMABLE OR COMBUSTIBLE MATERIALS
NFPA 86 : 2015 OVENS AND FURNACES
ASTM D 1186 : 2001 Standard Test Methods for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to a Ferrous Base (Withdrawn 2006)
ASTM D 1475 : 2013 : REDLINE Standard Test Method For Density of Liquid Coatings, Inks, and Related Products

View more information
US$75.00
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.