Standard Test Method for Measuring Nominal Thickness of Rolled Erosion Control Products

Available format(s)

PDF

Language(s)

English

Published date

02-13-2018

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 04.13, 2018 Specifies the measurement of the nominal thickness of permanent rolled erosion control products.

1.1This test method covers the measurement of the nominal thickness of rolled erosion control products.

1.2This test method does not provide thickness values for rolled erosion control products under variable compressive stresses. This test method determines nominal thickness, not necessarily minimum thickness.

1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 35
DevelopmentNote	Supersedes ASTM D 6525. (09/2014)
DocumentType	Redline
Pages	4
PublisherName	American Society for Testing and Materials
Status	Current

ASTM E 177 : 2014 : REDLINE	Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM D 4354 : 2012 : REDLINE	Standard Practice for Sampling of Geosynthetics and Rolled Erosion Control Products(RECPs) for Testing