Name: ASTM D 7238 : 2020
Brand: ASTM
Price: 55.00 USD

Standard Test Method for Effect of Exposure of Unreinforced Polyolefin Geomembrane Using Fluorescent UV Condensation Apparatus

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

07-08-2020

Publisher

American Society for Testing and Materials

1.1This standard covers the specific procedures and test conditions that are applicable for exposure of unreinforced polyolefin geomembranes to fluorescent UV radiation and condensation.

Note 1:Polyolefin geomembranes include high-density polyethylene (HDPE), linear low-density polyethylene (LLDPE), flexible polyproplyene (fPP), etc.

1.2Test specimens are exposed to fluorescent UVA-340 lamps under controlled environmental conditions. UVA-340 lamps are standard for this method.

Note 2:Other types of fluorescent UV lamps, such as UVB-313, can also be used based upon discussion between involved parties. However, if the test is run with another type of fluorescent UV lamp, such as UVB-313, this should be considered as a deviation from the standard and clearly stated in the test report. UVB-313 and UVA-340 fluorescent lamps generate different amounts of radiant power in different wavelength ranges; thus, the photochemical effects caused by these different lamps may vary.

1.3This method covers the conditions under which the exposure is to be performed and the test methods for evaluating the effects of fluorescent UV, heat, and moisture in the form of condensation on geomembranes. General guidance is given in Practices G151 and G154.

1.4The values listed in SI units are to be regarded as the standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 35
DocumentType	Test Method
Pages	4
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 7238 : 2006 : R2017

ASTM D 5819 : 2018

Standard Guide for Selecting Test Methods for Experimental Evaluation of Geosynthetic Durability

ASTM D 1238 : 2023	Standard Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer
ASTM D 1238 : 2023 : REV A	Standard Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer
ASTM G 154 : 2016	Standard Practice for Operating Fluorescent Ultraviolet (UV) Lamp Apparatus for Exposure of Nonmetallic Materials
ASTM G 154 : 2023	Standard Practice for Operating Fluorescent Ultraviolet (UV) Lamp Apparatus for Exposure of Materials
ASTM G 113 : 2016	Standard Terminology Relating to Natural and Artificial Weathering Tests of Nonmetallic Materials
ASTM D 1238 : 2020	Standard Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer
ASTM G 113 : 2022	Standard Terminology Relating to Natural and Artificial Weathering Tests of Nonmetallic Materials