Standard Specification for Metal Injection Molded Cobalt-28Chromium-6Molybdenum Components for Surgical Implant Applications

Available format(s)

PDF

Language(s)

English

Published date

10-18-2017

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 13.02, 2017 Defines the chemical, mechanical, and metallurgical requirements for metal injection molded (MIM) cobalt-28chromium-6molybdenum components to be used in the manufacture of surgical implants.

1.1This specification covers chemical, mechanical, and metallurgical requirements for metal injection molded (MIM) cobalt-28chromium-6molybdenum components to be used in the manufacture of surgical implants

1.2The MIM components covered by this specification may have been densified beyond their as-sintered density by post-sinter processing.

1.3Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	F 04
DocumentType	Redline
Pages	5
PublisherName	American Society for Testing and Materials
Status	Current

SAE AMS 2248 : 2016	CHEMICAL CHECK ANALYSIS LIMITS, CORROSION AND HEAT-RESISTANT STEELS AND ALLOYS, MARAGING AND OTHER HIGHLY-ALLOYED STEELS, AND IRON ALLOYS
SAE AMS 2269 : 2006	CHEMICAL CHECK ANALYSIS LIMITS, NICKEL, NICKEL ALLOYS, AND COBALT ALLOYS
ASTM B 311 : 2017 : REDLINE	Standard Test Method for Density of Powder Metallurgy (PM) Materials Containing Less Than Two Percent Porosity
ISO 6892:1998	Metallic materials Tensile testing at ambient temperature
IEEE/ASTM SI_10-2010	American National Standard for Metric Practice
ASTM F 629 : 2015 : REDLINE	Standard Practice for Radiography of Cast Metallic Surgical Implants
ASTM B 923 : 2016 : REDLINE	Standard Test Method for Metal Powder Skeletal Density by Helium or Nitrogen Pycnometry
ISO 9001:2015	Quality management systems — Requirements
ASTM F 1537 : 2011 : REDLINE	Standard Specification for Wrought Cobalt-28Chromium-6Molybdenum Alloys for Surgical Implants (UNS R31537, UNS R31538, and UNS R31539)
ASTM E 354 : 2014 : REDLINE	Standard Test Methods for Chemical Analysis of High-Temperature, Electrical, Magnetic, and Other Similar Iron, Nickel, and Cobalt Alloys
ASTM E 8/E8M : 2016-09	TEST METHODS FOR TENSION TESTING OF METALLIC MATERIALS