BS EN 60296:2012
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Fluids for electrotechnical applications. Unused mineral insulating oils for transformers and switchgear
Hardcopy , PDF
08-26-2020
English
05-31-2012
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Properties of oil
5 Classification, identification, general delivery
requirements and sampling
6 Properties, their significance and test methods
7 Specific requirements for special applications
Annex A (informative) - Potentially corrosive sulphur
Bibliography
Annex ZA (normative) - Normative references to
international publications with their
corresponding European publications
Annex ZB (normative) - Special national conditions
Covers specifications and test methods for unused mineral insulating oils.
This International Standard is applicable to specifications and test methods for unused mineral insulating oils (see Clause 3 for definitions). It applies to oil delivered to the agreed point and time of delivery, intended for use in transformers, switchgear and similar electrical equipment in which oil is required for insulation and heat transfer. These oils are obtained by refining, modifying and/or blending of petroleum products and other hydrocarbons.
Oils with and without additives are both within the scope of this standard.
This standard is applicable only to unused mineral insulating oils.
Recycled oils are beyond the scope of this standard.
NOTE Definitions and specifications for recycled oils will be covered by IEC 627011.
This standard does not apply to mineral insulating oils used as impregnants in cables or capacitors.
| Committee |
GEL/10
|
| DevelopmentNote |
Supersedes 09/30213528 DC. (05/2012)
|
| DocumentType |
Standard
|
| Pages |
28
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| NBN EN 60296 : 2012 | Identical |
| EN 60296:2012 | Identical |
| NF EN 60296 : 2014 | Identical |
| I.S. EN 60296:2012 | Identical |
| DIN EN 60296 : 2012 | Identical |
| UNE-EN 60296:2012 | Identical |
| IEC 60296:2012 RLV | Identical |
| 08/30167496 DC : DRAFT FEB 2008 | BS 148 - RECLAIMED MINERAL INSULATING OIL FOR TRANSFORMERS AND SWITCHGEAR - SPECIFICATION |
| BS 148:2009 | Reclaimed mineral insulating oil for transformers and switchgear. Specification |
| ISO 3016:1994 | Petroleum products Determination of pour point |
| ISO 2719:2016 | Determination of flash point — Pensky-Martens closed cup method |
| EN 60156:1995 | Insulating liquids - Determination of the breakdown voltage at power frequency - Test method |
| IEC 62021-1:2003 | Insulating liquids - Determination of acidity - Part 1: Automatic potentiometric titration |
| EN 60422:2013 | Mineral insulating oils in electrical equipment - Supervision and maintenance guidance |
| IEC 62021-2:2007 | Insulating liquids - Determination of acidity - Part 2: Colourimetric titration |
| IEC 61125:1992 | Unused hydrocarbon based insulating liquids - Test methods for evaluating the oxidation stability |
| ISO 3675:1998 | Crude petroleum and liquid petroleum products Laboratory determination of density Hydrometer method |
| EN ISO 3104:1996 | Petroleum products - Transparent and opaque liquids - Determination of kinematic viscosity and calculation of dynamic viscosity (ISO 3104:1994) |
| IEC 60422:2013 | Mineral insulating oils in electrical equipment - Supervision and maintenance guidance |
| IEC 60156:1995 | Insulating liquids - Determination of the breakdown voltage at power frequency - Test method |
| EN 61125:1993/A1:2004 | UNUSED HYDROCARBON-BASED INSULATING LIQUIDS - TEST METHODS FOR EVALUATING THE OXIDATION STABILITY |
| EN ISO 12185:1996 | Crude petroleum and petroleum products - Determination of density - Oscillating U-tube method (ISO 12185:1996) |
| EN 14210 : 2003 | SURFACE ACTIVE AGENTS - DETERMINATION OF INTERFACIAL TENSION OF SOLUTIONS OF SURFACE ACTIVE AGENTS BY THE STIRRUP OR RING METHOD |
| EN 61619:1997 | Insulating liquids - Contamination by polychlorinated biphenyls (PCBs) - Method of determination by capillary column gas chromatography |
| HD 488 : 200S3 | GASSING OF INSULATING LIQUIDS UNDER ELECTRICAL STRESS AND IONIZATION |
| ISO 6247:1998 | Petroleum products — Determination of foaming characteristics of lubricating oils |
| EN ISO 14596:2007 | Petroleum products - Determination of sulfur content - Wavelength-dispersive X-ray fluorescence spectrometry (ISO 14596:2007) |
| IEC 62535:2008 | Insulating liquids - Test method for detection of potentially corrosive sulphur in used and unused insulating oil |
| IEC 60475:2011 | Method of sampling insulating liquids |
| EN 61620:1999 | Insulating liquids - Determination of the dielectric dissipation factor by measurement of the conductance and capacitance - Test method |
| IEC 61868:1998 | Mineral insulating oils - Determination of kinematic viscosity at very low temperatures |
| EN ISO 3675:1998 | Crude petroleum and liquid petroleum products - Laboratory determination of density - Hydrometer method (ISO 3675:1998) |
| EN 61198:1994 | Mineral insulating oils - Methods for the determination of 2-furfural and related compounds |
| EN 60814:1997 | Insulating liquids - Oil-impregnated paper and pressboard - Determination of water by automatic coulometric Karl Fischer titration |
| EN 62021-2 : 2007 | INSULATING LIQUIDS - DETERMINATION OF ACIDITY - PART 2: COLOURIMETRIC TITRATION |
| EN 62535:2009 | Insulating liquids - Test method for detection of potentially corrosive sulphur in used and unused insulating oil |
| EN 60970:2007/corrigendum:2008 | INSULATING LIQUIDS - METHODS FOR COUNTING AND SIZING PARTICLES |
| ISO 12185:1996 | Crude petroleum and petroleum products — Determination of density — Oscillating U-tube method |
| IEC 60970:2007 | Insulating liquids - Methods for counting and sizing particles |
| IEC 62697-1:2012 | Test methods for quantitative determination of corrosive sulfur compounds in unused and used insulating liquids - Part 1: Test method for quantitative determination of dibenzyldisulfide (DBDS) |
| EN 60247:2004 | Insulating liquids - Measurement of relative permittivity, dielectric dissipation factor (tan d) and d.c. resistivity |
| IEC 60666:2010 | Detection and determination of specified additives in mineral insulating oils |
| IEC 61620:1998 | Insulating liquids - Determination of the dielectric dissipation factor by measurement of the conductance and capacitance - Test method |
| IEC 60867:1993 | Insulating liquids - Specifications for unused liquids based on synthetic aromatic hydrocarbons |
| IEC 60814:1997 | Insulating liquids - Oil-impregnated paper and pressboard - Determination of water by automatic coulometric Karl Fischer titration |
| IEC 60076-2:2011 | Power transformers - Part 2: Temperature rise for liquid-immersed transformers |
| EN ISO 2719:2016 | Determination of flash point - Pensky-Martens closed cup method (ISO 2719:2016) |
| IEC 60247:2004 | Insulating liquids - Measurement of relative permittivity, dielectric dissipation factor (tan d) and d.c. resistivity |
| EN 61868:1999 | Mineral insulating oils - Determination of kinematic viscosity at very low temperatures |
| ISO 14596:2007 | Petroleum products — Determination of sulfur content — Wavelength-dispersive X-ray fluorescence spectrometry |
| ASTM D 7150 : 2013 : REDLINE | Standard Test Method for the Determination of Gassing Characteristics of Insulating Liquids Under Thermal Stress |
| IEC 61619:1997 | Insulating liquids - Contamination by polychlorinated biphenyls (PCBs) - Method of determination by capillary column gas chromatography |
| EN 60076-2:2011 | Power transformers - Part 2: Temperature rise for liquid-immersed transformers |
| IEC 61198:1993 | Mineral insulating oils - Methods for the determination of 2-furfural and related compounds |
| EN 62021-1:2003 | Insulating liquids - Determination of acidity - Part 1: Automatic potentiometric titration |
| EN 60475 : 2011 | Method of sampling insulating liquids |
| EN 60666 : 2010 | DETECTION AND DETERMINATION OF SPECIFIED ADDITIVES IN MINERAL INSULATING OILS |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.