Provides the specific requirements for public electricity network distribution assemblies (PENDAs).

This part of IEC61439 defines the specific requirements for public electricity network distribution assemblies (PENDAs). PENDAs have the following criteria: used for the distribution of electrical energy in three phase systems for which the rated voltage does not exceed 1000V a.c. (see Figure101 for a typical distribution network); stationary; open assemblies are not covered by this standard; suitable for installation in places where only skilled persons have access for their use, however, outdoor types may be installed in situations that are accessible to ordinary persons; for indoor or outdoor use. The object of this standard is to state the definitions and to specify the service conditions, construction requirements, technical characteristics and tests for PENDAs. Network parameters may require tests at higher performance levels. PENDAs may also include control and or signalling devices associated with the distribution of electrical energy. This standard applies to all PENDAs whether they are designed, manufactured on a one-off basis or fully standardised and manufactured in quantity. The manufacture and/or assembly may be carried out other than by the original manufacturer (see 3.10.1 of IEC61439‑1:2011 ). This standard does not apply to individual devices and self-contained components, such as motor starters, fuse switches, electronic equipment, etc. which comply with the relevant product standards. This standard does not apply to specific types of assemblies covered by other parts of IEC61439 series. [Image removed.] NOTE1 If a PENDA is equipped with additional equipment (for example meters), in such a way that the main function is changed considerably, then other standards can also apply as agreed between user and manufacturer (see 8.5 of IEC61439‑1:2011 ). NOTE2 Where local regulations and practices permit, a PENDA according to this standard can be used in other than public networks.