BS EN 818-3 : 1999

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Hazards
5 Safety requirements
  5.1 General
  5.2 Dimensions
      5.2.1 Nominal size of chain, d[n]
      5.2.2 Tolerance on material diameter (except at the weld)
      5.2.3 Weld diameter
      5.2.4 Length dimensionally affected by welding
      5.2.5 Pitch and widths
  5.3 Materials and heat treatment
      5.3.1 General
      5.3.2 Quality of material
      5.3.3 Heat treatment
      5.3.4 Stainless steel
  5.4 Mechanical properties
      5.4.1 Manufacturing proof force (MPF)
      5.4.2 Breaking force (BF) and total ultimate elongation (A)
      5.4.3 Bend deflection
6 Verification of safety requirements
  6.1 Qualification of personnel
  6.2 Size of lot and selection of samples
  6.3 Manufacturing proof force, breaking force and total
      ultimate elongation
      6.3.1 Static tensile test
      6.3.2 Manufacturing proof force acceptance criteria
      6.3.3 Breaking force and total ultimate elongation
            acceptance criteria
  6.4 Bend deflection
      6.4.1 Bend test
      6.4.2 Bend deflection acceptance criteria
7 Marking
8 Manufacturer's certificate
9 Information for use
Annex A (informative) - Calculation of dimensions, working
        load limits and mechanical properties
      A.1 Dimensions and tolerances
      A.2 Working load limits and mechanical properties
Annex B (informative) - Mass of chain
Annex C (informative) - Designation system for chain (medium
        tolerance) - Grade 4
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 98/37/EC
Annex ZB (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 2006/42/EC
Bibliography