This clause of Part1 is applicable except as follows:

1.1 Scope

Replacement:

In general, this part of IEC60730 applies to energy regulators for use in, on, or in association with equipment, including energy regulators for heating, air conditioning and similar applications. The equipment may use electricity, gas, oil, solid fuel, solar thermal energy, etc. or a combination thereof.

NOTE These energy regulators can be thermally, mechanically or electrically operated.

This standard applies to the inherent safety, to the operating values, operating times and operating sequence where these are associated with equipment safety, and to the testing of automatic electrical energy regulator devices used in, or in association with, equipment.

This standard is also applicable to energy regulators for appliances within the scope of IEC60335-1.

Throughout this standard the word “equipment?? means “appliance and equipment??.

This standard also applies to automatic electrical energy regulators for equipment that may be used by the public, such as equipment intended to be used in shops, offices, hospitals, farms and commercial and industrial applications.

This standard does not apply to automatic electrical energy regulators designed exclusively for industrial process applications unless explicitly mentioned in the equipment standard.

This standard does not apply to equipment that are specifically within the scope of building automation equipment.

This standard is also applicable to individual energy regulators utilized as part of a control system or energy regulators which are mechanically integral with multi-functional controls having non-electrical outputs.

This standard applies to controls powered by primary or secondary batteries, requirements for which are contained within the standard, including AnnexV.

1.1.1 This International Standard applies to the inherent safety, to the operating values, operating times, and operating sequences where such are associated with equipment safety, and to the testing of automatic electrical control devices used in, or in association with, equipment.

This standard applies to controls using thermistors, see also AnnexJ.

This standard is also applicable to the functional safety of low complexity safety related systems and controls.

1.1.2 This standard applies to energy regulators as defined in 2.2.10 of Part1.

1.1.3 Not applicable.

1.1.4 Replacement:

This standard applies to manual energy regulators which are electrically and/or mechanically integral with automatic controls.

Requirements for manual switches not forming part of an automatic energy regulator are contained in IEC61058-1.

1.1.5 Replacement:

This standard applies to energy regulators with a rated voltage not exceeding 690V AC or 600V DC.

1.1.6 Not applicable.

1.1.7 Replacement:

This standard applies also to energy regulators incorporating electronic devices, requirements for which are contained in AnnexH.

1.1.8 This standard applies also to energy regulators using NTC or PTC thermistors, additional requirements for which are contained in AnnexJ.

1.1.9 This standard applies to the electrical and functional safety of controls capable of receiving and responding to communications signals, including signals for power billing rate and demand response.

The signals may be transmitted to or received from external units being part of the control (wired), or to and from external units which are not part of the control (wireless) under test.

1.1.10 This standard does not address the integrity of the output signal to the network devices, such as interoperability with other devices unless it has been evaluated as part of the control system.