• There are no items in your cart

BS IEC 1000-3.5 : 1994

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Available format(s)

Hardcopy , PDF

Superseded date

02-28-2010

Language(s)

English

Published date

01-01-1994

INTRODUCTION
1 Scope
2 Normative References
3 Definitions
4 Equipment assessment
   4.1 General
   4.2 Information from the consumer
   4.3 Information from the electricity supplier
   4.4 Information from the manufacturer
   4.5 Measurement procedure for the type test for
        equipment with a rated input current up to 75 A
        4.5.1 Test impedance Z*
        4.5.2 Test of equipment against Z*
        4.5.3 Evaluation against Zref
   4.6 Evaluation and declaration by the manufacturer
        of equipment with a rated input current up to
        75 A
        4.6.1 Check of the measured values against the
               limits contained in IEC 1000-3-3
        4.6.2 Calculation of the maximum permissable
               system impedance
   4.7 Evaluation of equipment with a rated input
        current exceeding 75 A
Annexes
A Recommended questionnaire for the consumer
B Recommended questionnaire for the electricity supplier
C Explanations
   C.1 Explanation of 4.5.1
   C.2 Explanation of 4.6.2
   C.3 Explanation of 4.7
D Diagrammatic representation of procedures to be
   followed in evaluating voltage fluctuations and
   flicker disturbances caused by equipment connected to
   the low-voltage public supply network

Deals with the emission of disturbances due to voltage fluctuations and flicker. Applies to electrical and electronic equipment meant to be connected to a public low-voltage a.c. distribution system, where the equipment has a rated input current over 16 A per phase, or has a lower rated current, but requires the special consent of the supply authority.

Committee
GEL/110
DevelopmentNote
Supersedes 90/28293 DC. (06/2005)
DocumentType
Standard
Pages
12
PublisherName
British Standards Institution
Status
Superseded
SupersededBy

BS IEC 1000-2.6 : 1995
BS IEC 1000-3.7 : 1996 ELECTROMAGNETIC COMPATIBILITY (EMC) - LIMITS - ASSESSMENT OF EMISSION LIMITS FOR FLUCTUATING LOADS IN MV AND HV POWER SYSTEMS - BASIC EMC PUBLICATION

IEC 61000-3-3 : 3.0EN+(REDLINE+VERSION) ELECTROMAGNETIC COMPATIBILITY (EMC) - PART 3-3: LIMITS - LIMITATION OF VOLTAGE CHANGES, VOLTAGE FLUCTUATIONS AND FLICKER IN PUBLIC LOW-VOLTAGE SUPPLY SYSTEMS, FOR EQUIPMENT WITH RATED CURRENT <= 16 A PER PHASE AND NOT SUBJECT TO CONDITIONAL CONNECTION

View more information
US$131.76
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.