BS IEC 61511-1 : 2003 AMD 15776
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
FUNCTIONAL SAFETY - SAFETY INSTRUMENTED SYSTEMS FOR THE PROCESS INDUSTRY SECTOR - PART 1: FRAMEWORK, DEFINITIONS, SYSTEM, HARDWARE AND SOFTWARE REQUIREMENTS
04-11-2005
11-23-2012
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Abbreviations and definitions
3.1 Abbreviations
3.2 Definitions
4 Conformance to this International Standard
5 Management of functional safety
5.1 Objective
5.2 Requirements
6 Safety life-cycle requirements
6.1 Objectives
6.2 Requirements
7 Verification
7.1 Objective
8 Process hazard and risk assessment
8.1 Objectives
8.2 Requirements
9 Allocation of safety functions to protection layers
9.1 Objective
9.2 Requirements of the allocation process
9.3 Additional requirements for safety integrity
level 4
9.4 Requirements on the basic process control
system as a protection layer
9.5 Requirements for preventing common cause,
common mode and dependent failures
10 SIS safety requirements specification
10.1 Objective
10.2 General requirements
10.3 SIS safety requirements
11 SIS design and engineering
11.1 Objective
11.2 General requirements
11.3 Requirements for system behaviour on detection
of a fault
11.4 Requirements for hardware fault tolerance
11.5 Requirements for selection of components and
subsystems
11.6 Field devices
11.7 Interfaces
11.8 Maintenance or testing design requirements
11.9 SIF probability of failure
12 Requirements for application software, including
selection criteria for utility software
12.1 Application software safety life-cycle
requirements
12.2 Application software safety requirements
specification
12.3 Application software safety validation planning
12.4 Application software design and development
12.5 Integration of the application software with the
SIS subsystem
12.6 FPL and LVL software modification procedures
12.7 Application software verification
13 Factory acceptance testing (FAT)
13.1 Objectives
13.2 Recommendations
14 SIS installation and commissioning
14.1 Objectives
14.2 Requirements
15 SIS safety validation
15.1 Objective
15.2 Requirements
16 SIS operation and maintenance
16.1 Objectives
16.2 Requirements
16.3 Proof testing and inspection
17 SIS modification
17.1 Objectives
17.2 Requirements
18 SIS decommissioning
18.1 Objectives
18.2 Requirements
19 Information and documentation requirements
19.1 Objectives
19.2 Requirements
Annex A (informative) Differences
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.