CSA C22.2 No. 2556 : 2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
WIRE AND CABLE TEST METHODS
Hardcopy , PDF
11-02-2020
English
01-01-2015
PREFACE
1 Scope
2 General
3 Conductor tests
4 Insulation, overall covering, and jacket materials tests
5 Components tests
6 Electrical tests for finished wire and cable
7 Mechanical tests for finished wire and cable
8 Environmental tests for finished wire and cable
9 Burning characteristics tests
Annex A (informative) - Conductor removal from
insulation for tubular specimens
Annex B (informative) - Determination of density
Annex C (informative) - Sample calculation for the
determination of ultimate elongation or tensile
strength at 300 d
Annex D (normative) - Establishment of parameters
and requirements for short-term air oven aging test
Annex E (normative) - Determination of temperature
correction factor
Annex F (normative) - Procedure and calculations for
determining the degree of coverage of fibrous
coverings
Annex G (normative) - Calculation of coverage of
shielding (wraps and braids)
Annex H (normative) - Test enclosure and exhaust duct
Annex I (informative) - Conversion of pH to acid gas
(as % HCl) and acid gas (as % HCl) to pH
Annex J (informative) - Correlation of NMX wire and
cable test method standards with
UL 2556/CSA C22.2 No. 2556
Specifies the apparatus, test methods, and formulas to be used in carrying out the tests and calculations required by wire and cable standards.
DevelopmentNote |
Also numbered as ANCE NMX-J-556 and UL 2556. (11/2005)
|
DocumentType |
Standard
|
Pages |
252
|
PublisherName |
Canadian Standards Association
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
C22.2 NO. 56-17 | Flexible metal conduit and liquid-tight flexible metal conduit |
CSA C22.2 No. 179 : 2009 : INC : UPD 1 : 2015 : R201400 | AIRPORT SERIES LIGHTING CABLES |
CSA C22.2 No. 35:2009 | EXTRA-LOW-VOLTAGE CONTROL CIRCUIT CABLE, LOW-ENERGY CONTROL CABLE, AND EXTRA-LOW-VOLTAGE CONTROL CABLE |
CSA C22.2 No. 131 : 2014 | TYPE TECK 90 CABLE |
CSA C68.5 : 2013 | SHIELDED AND CONCENTRIC NEUTRAL POWER CABLE FOR DISTRIBUTION UTILITIES |
CSA C22.2 No. 21 : 2014 | CORD SETS AND POWER-SUPPLY CORDS |
CSA C22.2 No. 48 : 2015 | NONMETALLIC SHEATHED CABLE |
IEEE 1242-1999 | IEEE Guide for Specifying and Selecting Power, Control, and Special-Purpose Cable for Petroleum and Chemical Plants |
CSA C22.2 No. 239 : 2017 | CONTROL AND INSTRUMENTATION CABLES |
CSA C22.2 No. 271 : 2011 : R2016 | PHOTOVOLTAIC CABLES |
CSA C22.2 No. 113 : 2015 | FANS AND VENTILATORS |
CSA C68.10 : 2014 | SHIELDED POWER CABLE FOR COMMERCIAL AND INDUSTRIAL APPLICATIONS, 5-46 KV |
CSA C22.2 No. 271 : 2011 : INC : UPD 1 : 2013 | PHOTOVOLTAIC CABLES |
CSA C22.2 No. 0.3 :2009 | TEST METHODS FOR ELECTRICAL WIRES AND CABLES |
CSA C61089 : 2011 | ROUND WIRE CONCENTRIC LAY OVERHEAD ELECTRICAL STRANDED CONDUCTORS |
CSA C68.9 : 2009 : INC : UPD 2 : 2012 | COVERED OVERHEAD DISTRIBUTION LINE WIRE |
CSA C22.2 No. 179 : 2009 | AIRPORT SERIES LIGHTING CABLES |
CSA C22.2 No. 130 : 2016 | REQUIREMENTS FOR ELECTRICAL RESISTANCE TRACE HEATING AND HEATING DEVICE SETS |
CSA C22.2 No. 179 : 2 | AIRPORT SERIES LIGHTING CABLES |
CSA C22.2 No. 49 : 2014 | FLEXIBLE CORDS AND CABLES |
N293-12 (R2017) | Fire protection for nuclear power plants |
CSA M421 : 2011 | USE OF ELECTRICITY IN MINES |
IEEE 532-2007 REDLINE | IEEE Guide for Selecting and Testing Jackets for Power, Instrumentation, and Control Cables |
CSA C68.9 : 2009(R2014) | COVERED OVERHEAD DISTRIBUTION LINE WIRE |
CSA C68.9:09 (R2018) | Covered overhead distribution line wire |
CSA C22.2 No. 271 : 2011 | PHOTOVOLTAIC CABLES |
CSA C61089 : 2011 : INC : UPD 3 : 2016 : R201500 | ROUND WIRE CONCENTRIC LAY OVERHEAD ELECTRICAL STRANDED CONDUCTORS |
CSA C61089 : 2011 : FR | ROUND WIRE CONCENTRIC LAY OVERHEAD ELECTRICAL STRANDED CONDUCTORS |
C22.2 NO. 174-18 | Cables and cable glands for use in hazardous locations |
CAN/CSA-C22.2 NO. 60079-30-1:17 | Explosive atmospheres - Part 30-1: Electrical resistance trace heating - General and testing requirements (Adopted IEC/IEEE 60079-30-1:2015, first edition, 2015-09, with Canadian deviations) |
CSA C22.2 No. 293.1 : 2017 | SKIN EFFECT TRACE HEATING OF PIPELINES, VESSELS, EQUIPMENT, AND STRUCTURES - GENERAL, TESTING, MARKING, AND DOCUMENTATION REQUIREMENTS |
CSA C22.2 No. 0.3 : 2009 : R2014 | TEST METHODS FOR ELECTRICAL WIRES AND CABLES |
CSA C22.2 NO No. 51:14 (R2018) | ARMOURED CABLES |
CSA C22.2 No. 35 : 2009 : R2014 | EXTRA-LOW-VOLTAGE CONTROL CIRCUIT CABLE, LOW-ENERGY CONTROL CABLE, AND EXTRA-LOW-VOLTAGE CONTROL CABLE |
CSA C22.2 NO No. 298 : 2016 | HIGH VOLTAGE COUPLERS |
C22.2 NO. 75-17 | Thermoplastic insulated wires and cables (Trinational standard with UL 83 and NMX-J-010-ANCE-2017) |
CSA N293 : 2012 : INC : UPD 1 : 2017 : R201700 | FIRE PROTECTION FOR NUCLEAR POWER PLANTS |
CSA C22.2 No. 112 : 2015 | ELECTRIC CLOTHES DRYERS |
UL 444:5ED 2017-01 | Communications Cables |
CSA M421 : 2011 : R2016 | USE OF ELECTRICITY IN MINES |
CSA N293 : 2012(R2018) | FIRE PROTECTION FOR NUCLEAR POWER PLANTS |
CSA C22.2 No. 272 : 2014 | WIND TURBINE ELECTRICAL SYSTEMS |
CSA N293 : 2012 | FIRE PROTECTION FOR NUCLEAR POWER PLANTS |
CSA C68.8 : 2011 | OVERHEAD ALUMINUM SECONDARY AND SERVICE-ENTRANCE CABLES AND CONDUCTORS FOR ELECTRICAL DISTRIBUTION UTILITIES |
CSA C22.2 No. 124 : 2016 | MINERAL-INSULATED CABLE |
C22.2 NO. 233-17 | Cords and cord sets for communication systems |
C22.2 NO. 331-17 | Flat cable systems |
CSA C68.7 : 2011 : R2015 | UNDERGROUND SECONDARY AND SERVICE-ENTRANCE CABLE FOR ELECTRICAL DISTRIBUTION UTILITIES |
CSA C22.2 No. 179 : 2009 : R2014 | AIRPORT SERIES LIGHTING CABLES |
CSA C68.7 : 2011 | UNDERGROUND SECONDARY AND SERVICE-ENTRANCE CABLE FOR ELECTRICAL DISTRIBUTION UTILITIES |
CSA C61089 : 2011 : INC : UPD 1 : 2014 | ROUND WIRE CONCENTRIC LAY OVERHEAD ELECTRICAL STRANDED CONDUCTORS |
C22.2 NO. 38-18 | THERMOSET-INSULATED WIRES AND CABLES |
C22.2 NO. 40-17 | Junction and pull boxes |
CSA C68.9 : 2009 : INC : UPD 1 : 2011 | COVERED OVERHEAD DISTRIBUTION LINE WIRE |
CSA C22.2 No. 208 : 2014 | FIRE ALARM AND SIGNAL CABLE |
C22.2 NO. 52-17 | Underground secondary and service-entrance cables |
CSA C22.2 No. 35 : 2009 : INC : UPD 2 : 2014 | EXTRA-LOW-VOLTAGE CONTROL CIRCUIT CABLE, LOW-ENERGY CONTROL CABLE, AND EXTRA-LOW-VOLTAGE CONTROL CABLE |
UL 83:16ED 2017-07 | Standard for Thermoplastic-Insulated Wires and Cables |
CSA C22.2 No. 198.4 : 2014 | EXPANDABLE SLEEVING FOR WIRE AND CABLE |
C22.2 NO. 127-18 | Equipment and lead wires |
C22.2 NO. 232-17 | Optical fiber cables |
CSA C22.2 No. 123 : 2016 | METAL SHEATHED CABLES |
CSA C61089 : 2011 : R2015 | ROUND WIRE CONCENTRIC LAY OVERHEAD ELECTRICAL STRANDED CONDUCTORS |
C22.2 NO. 230-17 | Tray cables |
C22.2 NO. 214-17 | Communications cables (Bi-national standard, with UL 444) |
C22.2 NO. 96.2-18 | Flexible power cables for wind turbine applications rated up to 35 kV |
CSA C22.2 No. 96.1 : 2016 | MINE POWER FEEDER CABLES |
CSA C22.2 No. 150 : 2016 | MICROWAVE OVENS |
CSA C22.2 No. 210 : 2015 | APPLIANCE WIRING MATERIAL PRODUCTS |
CSA C22.2 NO. 129:10 (R2019) | Neutral-supported cables |
C22.2 NO. 245-17 | Marine shipboard cable |
IEEE/CSA 844.1/CSA C22.2 No.293.1-2017 | IEEE/CSA Standard for Skin Effect Trace Heating of Pipelines, Vessels, Equipment, and Structures - General, Testing, Marking, and Documentation Requirements |
ISO 10093:1998 | Plastics Fire tests Standard ignition sources |
C22.1-15 | Canadian Electrical Code, Part I (23rd Edition), Safety Standard for Electrical Installations |
ASTM G 153 : 2013 : REDLINE | Standard Practice for Operating Enclosed Carbon Arc Light Apparatus for Exposure of Nonmetallic Materials |
ASTM D 5374 : 2013 : REDLINE | Standard Test Methods for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation |
ASTM A 29/A29M : 2016 : REDLINE | Standard Specification for General Requirements for Steel Bars, Carbon and Alloy, Hot-Wrought |
GPA 2140 : 2017 | LIQUEFIED PETROLEUM GAS SPECIFICATIONS AND TEST METHODS |
ASTM D 5207 : 2014 : REDLINE | Standard Practice for Confirmation of 20–mm (50–W) and 125–mm (500–W) Test Flames for Small-Scale Burning Tests on Plastic Materials |
ASTM D 1603 : 2014 : REDLINE | Standard Test Method for Carbon Black Content in Olefin Plastics |
NEMA VE 1:2017 | Metal Cable Tray Systems |
IEC 60695-11-3:2012 | Fire hazard testing - Part 11-3: Test flames - 500 W flames - Apparatus and confirmational test methods |
ASTM E 662 : 2017-02 | TEST METHOD FOR SPECIFIC OPTICAL DENSITY OF SMOKE GENERATED BY SOLID MATERIALS |
ASTM G 155 : 2013 : REDLINE | Standard Practice for Operating Xenon Arc Light Apparatus for Exposure of Non-Metallic Materials |
C22.2 NO. 126.1-17 | Metal cable tray systems (Binational standard with NEMA VE 1-2017) |
ASTM D 471 : 2016-02 | TEST METHOD FOR RUBBER PROPERTY - EFFECT OF LIQUIDS |
ASTM D 470 : 2013 : REDLINE | Standard Test Methods for Crosslinked Insulations and Jackets for Wire and Cable |
ASTM E 8/E8M : 2016-09 | TEST METHODS FOR TENSION TESTING OF METALLIC MATERIALS |
ASTM D 5423 : 2014 | Standard Specification for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.