I.S. EN 1090-1 & 2 (SET):1900

PART 1: REQUIREMENTS FOR CONFORMITY
        ASSESSMENT OF STRUCTURAL COMPONENTS
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
4 Requirements
5 Evaluation methods
6 Evaluation of conformity
7 Classification and designation
8 Marking
Annex A (informative) - Guidelines for preparation
        of the component specification
Annex B (normative) - Assessment of factory production
        control
Annex ZA (informative) - Clauses of this European
         Standard Addressing the provisions of EU
         Construction Products Directive (CPD)
Bibliography
PART 2: TECHNICAL REQUIREMENTS FOR STEEL STRUCTURES
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Specifications and documentation
5 Constituent products
6 Preparation and assembly
7 Welding
8 Mechanical fastening
9 Erection
10 Surface treatment
11 Geometrical tolerances
12 Inspection, testing and correction
Annex A (normative) - Additional information, list of
        options and requirements related to the execution
        classes
Annex B (informative) - Guidance for the determination
        of execution classes
Annex C (informative) - Check-list for the content of a
        quality plan
Annex D (normative) - Geometrical tolerances
Annex E (informative) - Welded joints in hollow sections
Annex F (normative) - Corrosion protection
Annex G (normative) - Test to determine slip factor
Annex H (normative) - Calibration test for preloaded
        bolts under site conditions
Annex J (normative) - Use of compressible washer-type
        direct tension indicators
Annex K (informative) - Hexagon injection bolts
Annex L (informative) - Guide to flow diagram for
        development and use of a WPS
Annex M (normative) - Sequential method for fasteners
        inspection
Bibliography