Preview

I.S. EN 1636-5:1998

Superseded

View Superseded by

Preview

PLASTICS PIPING SYSTEMS FOR NON-PRESSURE DRAINAGE AND SEWERAGE - GLASS-REINFORCED THERMOSETTING PLASTICS (GRP) BASED ON UNSATURATED POLYESTER RESIN (UP) - PART 5: FITNESS FOR PURPOSE OF THE JOINTS

Available format(s)

Hardcopy , PDF

Superseded date

06-16-2006

Language(s)

English

Published date

01-01-1998

Publisher

National Standards Authority of Ireland

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

Foreword
Introduction
1. Scope
2. Normative references
3. Definitions
4. Interchangeability
5. Joints
   5.1 Dimensions
   5.2 Flexible and reduced-articulation joints with
       elastomeric sealing components

Describes the characteristics of the fitness for purpose of glass-reinforced thermosetting plastics based on unsaturated polyester resin (GRP-UP) piping systems intended to be used for non-pressure drainage and sewerage. Also specifies the relevant test parameters for the test methods referred to in this standard which are applicable to the joints to be used in GRP-UP piping systems to be used for the conveyance of surface water or sewage below ground, outside buildings, at temperature up to 50 degree C.

DocumentType	Standard
Pages	20
PublisherName	National Standards Authority of Ireland
Status	Superseded
SupersededBy	I.S. EN 14364:2006

Standards	Relationship
EN 1636-5 : 1997	Identical
DIN EN 1636-5:1999-12	Identical
SN EN 1636-5 : 1998	Identical
NF EN 1636-5 : 1997	Identical
BS EN 1636-5:2001	Identical
NBN EN 1636-5 : 1997	Identical
UNE-EN 1636-5:1998	Identical
UNI EN 1636-5 : 1999	Identical
NS EN 1636-5 : 1ED 1997	Identical
NEN EN 1636-5 : 1997	Identical