FOREWORD
INTRODUCTION
1 Scope and object
2 Normative references
3 Terms and definitions
4 Relationships of mechanical loads
   4.1 Loads from outside the insulator
   4.2 Pressures
5 Marking
6 Classification of tests
   6.1 Design tests
   6.2 Type tests
   6.3 Sample tests
   6.4 Routine tests
7 Design tests
   7.1 General
   7.2 Tests on interfaces and connections of end fittings
   7.3 Tests on shed and housing material
   7.4 Tests on the tube material
8 Type tests (only mechanical tests)
   8.1 General
   8.2 Test specimens
   8.3 Preparation of the test specimen
   8.4 Internal pressure test
   8.5 Bending test
9 Sample tests
   9.1 Selection and number of insulators
   9.2 Testing
   9.3 Verification of dimensions
   9.4 Mechanical tests
   9.5 Galvanizing test
   9.6 Check of the interface between end fittings and
        the housing
   9.7 Re-test procedure
10 Routine tests
   10.1 General
   10.2 Visual examination
   10.3 Routine pressure test
   10.4 Routine mechanical test
   10.5 Routine tightness test
11 Documentation
Annex A (normative) - Tolerances of form and position
Annex B (informative) - General recommendations for design
                        and construction
Annex C (informative) - Principles of damage limit and use of
                        reversible and irreversible strain
                        caused by internal pressure and/or
                        bending loads on composite hollow
                        insulator tubes
Annex ZA (normative) - Normative references to international
                       publications with their corresponding
                       European publications
Bibliography