I.S. EN 62199:2004
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
BUSHINGS FOR D.C. APPLICATION
Hardcopy , PDF
02-20-2021
English
01-01-2004
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Ratings
4.1 Rated voltages
4.2 Insulation levels
4.3 Rated currents
4.4 Minimum nominal creepage distance
5 Operating conditions
5.1 General
5.2 Factors affecting the design, testing and application
6 General requirements
6.1 List of variables
6.2 Nameplate markings
7 Test requirements
7.1 General requirements
7.2 Test classification
8 Type tests
8.1 Dry power-frequency voltage withstand test with
partial discharge measurement
8.2 Dry lightning impulse voltage withstand test (BIL)
8.3 Dry or wet switching impulse voltage withstand
8.4 Temperature rise test
8.5 Cantilever load withstand test
8.6 Tightness test on liquid-filled, compound-filled
and liquid-insulated bushings
8.7 Internal pressure test on gas-filled, gas-insulated
and gas-impregnated bushings
8.8 Verification of dimensions
9 Routine tests
9.1 Measurement of dielectric dissipation factor
(tan delta) and capacitances
9.2 Dry lightning impulse voltage withstand test (BIL)
9.3 Dry power-frequency voltage withstand test with
partial discharge measurement
9.4 DC applied voltage withstand test with partial
discharge measurement
9.5 Polarity reversal test with partial discharge
measurement
9.6 Test of tap insulation
9.7 Internal pressure test on gas-filled, gas-insulated
and gas-impregnated bushings
9.8 Tightness test on liquid-filled, compound-filled
and liquid-insulted bushings
9.9 Tightness test on gas-filled, gas-insulated and
gas-impregnated bushings
9.10 Tightness test at the flange or other fixing device
9.11 Visual inspection and dimensional check
10 Special tests
10.1 Artificial pollution test
10.2 Even wetting d.c. voltage test
10.3 Uneven wetting d.c. voltage test
Annex ZA (normative) Normative references to international
publications with their corresponding
European publications
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.