I.S. EN 730:1995
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
GAS WELDING EQUIPMENT - EQUIPMENT USED IN GAS WELDING, CUTTING AND ALLIED PROCESSES, SAFETY DEVICES FOR FUEL GASES AND OXYGEN OR COMPRESSED AIR - GENERAL SPECIFICATIONS, REQUIREMENTS AND TESTS
Hardcopy , PDF
11-08-2002
English
01-01-1995
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
1 Scope
2 Normative references
3 Definitions and functions
3.1 Safety devices
3.2 Non return valve
3.3 Flame arrestor
3.4 Pressure relief valve
3.5 Cut off valves
3.6 Multifunctional device
4 Design and materials
4.1 Design
4.2 Materials
5 Requirements
5.1 Requirements common to all devices
5.2 Requirements applicable to each type of device
6 Tests
6.1 General
6.2 Reference values and accuracy of instruments
6.3 Conformity testing
6.4 Test gases
6.5 Test methods common to all devices
6.6 Tests applicable to each specific type of device
7 Manufacturers instructions
8 Marking
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.