I.S. EN 81-40:2008
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
10-27-2020
English
01-01-2008
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or protective measures
5.1 General
5.1.1 Introduction
5.1.2 Pattern of use
5.1.3 Access for maintenance, repair and inspection
5.1.4 Fire resistance
5.1.5 Rated speed
5.1.6 Rated load
5.1.7 Resistance to operating forces
5.1.8 Protection of equipment against harmful external
influences
5.1.9 Guarding of equipment from mechanical damage
5.2 Guide rails and mechanical stops
5.2.1 Guide rails
5.2.2 Folding guide rails
5.2.3 Stairlift guide rail
5.2.4 Rail design
5.3 Safety gear and overspeed detection device
5.3.1 General
5.3.2 Control
5.3.3 Release
5.3.4 Access for inspection
5.3.5 Electrical checking
5.3.6 Overspeed detection device
5.3.7 Rotation monitor unit
5.3.8 Safety nut
5.4 Driving units and drive system
5.4.1 General requirements
5.4.2 Braking system
5.4.3 Emergency/manual operation
5.4.4 Additional requirements for rope suspension drive
5.4.5 Additional requirements for rack and pinion drive
5.4.6 Additional requirements for chain suspension drive
5.4.7 Additional requirements for screw and nut drive
5.4.8 Additional requirements for friction/traction drive
5.4.9 Additional requirements for guided rope and ball drive
5.5 Electrical installation and equipment
5.5.1 General
5.5.2 Drive contactors
5.5.3 Motor and brake circuits for stopping the machine
and checking its stopped condition
5.5.4 Creepage and clearance distances and enclosure
requirements
5.5.5 Protection against electrical faults
5.5.6 Electric safety devices
5.5.7 Time delay
5.5.8 Protection of the driving motor
5.5.9 Electrical wiring
5.5.10 Safety circuits
5.5.11 Residual current devices
5.5.12 Additional requirements for battery powered operation
5.5.13 Cableless controls
5.5.14 Control devices
5.5.15 Terminal limit switches and final limit electric
safety devices
5.5.16 Emergency alarm devices and warning signals
5.5.17 Socket outlet
5.6 Carriage
5.6.1 Combined type of carriage
5.6.2 Chair
5.6.3 Carriage with standing platform
5.6.4 Carriage with wheelchair platform
6 Verification of safety requirements and/or protective measures
6.1 General
6.2 Verification of design
6.3 Examinations and tests before putting into service
6.4 Verification tests on each machine before first use
7 Information for use
7.1 General
7.2 Signals and warning devices
7.3 Accompanying documents (in particular: Instruction handbook)
7.3.1 General
7.4 Marking
7.4.1 Carriage
7.4.2 Emergency alarm device
7.4.3 Disabled persons symbol
7.4.4 Emergency manual operation
7.5 The additional information given to the installer
7.5.1 Dedicated electrical supply
Annex A (normative) Verification type tests for overspeed
detection device and safety gear
A.1 Instruments
A.2 Safety gear and overspeed detection device
A.2.1 General provisions
A.2.2 Method of test
A.2.3 Test report
Annex B (normative) Electronic components: failure exclusion
Annex C (informative) Guidance in selection of stairlifts
C.1 Introduction
C.2 Selection of stairlift
C.2.1 Suitability
C.2.2 Control devices
C.2.3 Location of the stairlift
C.2.4 Duty cycle
C.3 Electrical supply and lighting
C.4 Maintenance
C.5 Alarm system
Annex D (informative) Recommendations for the provisions and
use of specially adapted control devices, switches
and sensors
D.1 Control devices
D.2 Specially adapted switches
Annex E (informative) In-use periodic examination, tests
and servicing
E.1 Periodic examinations and tests
E.2 Servicing
Annex ZA (informative) Relationship between this European
Standard and the Essential Requirements of the EU
Directive 98/37EC
Annex ZB (informative) Relationship between this European
Standard and the Essential Requirements of the EU
Directive 2006/42/EC
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.