I.S. EN 919:1996
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
FIBRE ROPES FOR GENERAL SERVICE - DETERMINATION OF CERTAIN PHYSICAL AND MECHANICAL PROPERTIES
Hardcopy , PDF
05-05-2005
English
01-01-1996
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
1 Scope
2 Normative references
3 Definitions
3.1 Sheet
3.2 Length of sheet
3.3 Width of sheet
3.4 Strip
3.5 Master coil
3.6 Inspection lot
3.7 Sample
3.8 Specimen
3.9 Test piece
3.10 Test
4 Technical conditions for inspection and delivery
4.1 Orders of tenders
4.2 Requirements
4.3 Test procedure
4.3.1 Sampling
4.3.2 Test methods
4.3.3 Retests
5 Mechanical properties
5.1 Tensile
5.2 Earing
6 Tolerances on dimensions and form
6.1 Thickness
6.2 Length and width
6.2.1 Strip
6.2.2 Sheet
6.3 Straightness of the longitudinal edge (sheet and
strip
6.4 Squareness of sheet
6.5 Flatness
6.6 Longitudinal curvature (longitudinal bow)
6.6.1 Strip
6.6.2 Sheet
7 Surface finish
7.1 Surface condition
7.2 Lacquering
7.3 Lubricants
7.4 Food and health legislation
7.5 Surface roughness
7.6 Surface appearance
8 Inspection documents
8.1 General
8.2 Documents established on the basis of inspections
and tests performed by qualified personnel who are
involved in the manufacturing process and/or belong
to the quality control department
8.2.1 Certificate of conformity
8.2.2 Specific test reports
8.3 Documents established on the basis of inspections
and tests performed or supervised by qualified
personnel organizationally independent from the
manufacturing department, according to the
requirements specified on the order and carried
out on the products for delivery or on the
relevant inspection lot
9 Labelling
10 Packaging
11 Arbitration
Annexes
A (normative) List of aluminium and aluminium alloys
B (normative) Rules for rounding
C (informative) Temper designations
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.