I.S. EN IEC 61347-2-14:2018
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
12-31-2021
05-27-2018
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
National Foreword
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
8 Protection against accidental contact with live parts
9 Terminals
10 Provisions for earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings
14 Fault conditions
15 Protection of associated components
16 Abnormal conditions
17 Construction
18 Creepage distances and clearances
19 Screws, current-carrying parts and connections
20 Resistance to heat, fire and tracking
21 Resistance to corrosion
Annex A (normative) - Test to establish whether a
conductive part is a live part which
may cause an electric shock
Annex B (normative) - Particular requirements for thermally
protected lamp controlgear
Annex C (normative) - Particular requirements for electronic
lamp controlgear with means of protection
against overheating
Annex D (normative) - Requirements for carrying out
the heating tests of thermally protected lamp
controlgear
Annex E (normative) - Use of constant S other
than 4500 in t[w] tests
Annex F (normative) - Draught-proof enclosure
Annex G (normative) - Explanation of the derivation of
the values of pulse voltages
Annex H (normative) - Tests
Annex I (normative) - Additional requirements for built-in
magnetic ballast with double or reinforced insulation
Annex J (normative) - Particular additional safety requirements
for DC and/or AC supplied electronic controlgear for
emergency lighting
Annex K (informative) - Conformity testing during manufacture
Annex L (normative) - Particular additional requirements for
controlgear providing SELV
Annex M (informative) - Dielectric strength test voltages for
controlgear intended for the use in impulse
withstand Category III
Annex N (normative) - Requirements for insulation
materials used for double or reinforced insulation
Annex O (normative) - Additional requirements for built-in
electronic controlgear with double or reinforced insulation
Annex P (normative) - Creepage distances and clearances
and distance through insulation (DTI) for lamp controlgear
which are protected against pollution by the use
of coating or potting
Annex Q (informative) - Example for U[p] calculation
Annex R (informative) - Concept of creepage distances and
clearances
Annex S (informative) - Examples of controlgear insulation
coordination
Annex T (informative) - Creepage distances and clearances
for controlgear with a higher degree of availability
(impulse withstand category III)
Bibliography
Annex ZA (normative) - Normative references to
international publications with their
corresponding European publications
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.