Preview

I.S. EN IEC 61730-2:2018

Superseded

View Superseded by

Preview

PHOTOVOLTAIC (PV) MODULE SAFETY QUALIFICATION - PART 2: REQUIREMENTS FOR TESTING

Available format(s)

Hardcopy , PDF

Superseded date

01-27-2020

Published date

05-15-2018

Publisher

National Standards Authority of Ireland

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

National Foreword
FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 Test categories
5 Classes and their necessary test procedures
6 Sampling
7 Test report
8 Testing
9 Pass criteria
10 Test procedures
Annex A (informative) - Recommendations for testing
        of PV modules from production
Annex B (informative) - Fire tests, spread-of-flame and
        burning-brand tests for PV modules
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications
Annex ZZ (informative) - Relationship between
         this European standard and the safety
         objectives of Directive 2014/35/EU [2014 OJ L96]
         aimed to be covered

Defines the testing sequence intended to verify the safety of PV modules whose construction has been assessed by IEC 61730-1.

Committee	TC 82
DevelopmentNote	Supersedes I.S. EN 61730-2. For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (05/2018)
DocumentType	Standard
ISBN	978-2-8322-3575-1
Pages	132
ProductNote	The date of any NSAI previous adoption may not match the date of its original CEN/CENELEC document.
PublisherName	National Standards Authority of Ireland
Status	Superseded
SupersededBy	I.S. EN IEC 61730-2:2018&AC:2018-06

Standards	Relationship
IEC 61730-2:2016	Identical
EN IEC 61730-2:2018	Identical

IEC 60950-1:2005+AMD1:2009+AMD2:2013 CSV	Information technology equipment - Safety - Part 1: General requirements
ISO/IEC 17025:2005	General requirements for the competence of testing and calibration laboratories
EN 60904-2:2015	Photovoltaic devices - Part 2: Requirements for photovoltaic reference devices
EN 60904-9 : 2007	PHOTOVOLTAIC DEVICES - PART 9: SOLAR SIMULATOR PERFORMANCE REQUIREMENTS
ANSI Z97.1 : 2015	SAFETY GLAZING MATERIALS USED IN BUILDINGS - SAFETY PERFORMANCE SPECIFICATIONS AND METHODS OF TEST
ISO 813:2016	Rubber, vulcanized or thermoplastic Determination of adhesion to a rigid substrate 90 degree peel method
IEC 60904-9:2007	Photovoltaic devices - Part 9: Solar simulator performance requirements
EN 60068-2-1:2007	Environmental testing - Part 2-1: Tests - Test A: Cold
ISO 23529:2016	Rubber General procedures for preparing and conditioning test pieces for physical test methods
EN 60068-2-2:2007	Environmental testing - Part 2-2: Tests - Test B: Dry heat
EN 60060-1:2010	High-voltage test techniques - Part 1: General definitions and test requirements
ISO 8124-1:2014	Safety of toys Part 1: Safety aspects related to mechanical and physical properties
EN 60950-1:2006/A2:2013	INFORMATION TECHNOLOGY EQUIPMENT - SAFETY - PART 1: GENERAL REQUIREMENTS (IEC 60950-1:2005/A2:2013, MODIFIED)
EN 61730-1:2007/A11:2014	PHOTOVOLTAIC (PV) MODULE SAFETY QUALIFICATION - PART 1: REQUIREMENTS FOR CONSTRUCTION (IEC 61730-1:2004, MODIFIED)
ISO 11925-2:2010	Reaction to fire tests Ignitability of products subjected to direct impingement of flame Part 2: Single-flame source test
EN 60068-3-5:2002	Environmental testing - Part 3-5: Supporting documentation and guidance - Confirmation of the performance of temperature chambers
ISO 4587:2003	Adhesives Determination of tensile lap-shear strength of rigid-to-rigid bonded assemblies
IEC 60068-3-5:2001	Environmental testing - Part 3-5: Supporting documentation and guidance - Confirmation of the performance of temperature chambers
EN 60695-2-10:2013	Fire hazard testing - Part 2-10: Glowing/hot-wire based test methods - Glow-wire apparatus and common test procedure
IEC 61730-1:2016	Photovoltaic (PV) module safety qualification - Part 1: Requirements for construction
IEC 60068-2-2:2007	Environmental testing - Part 2-2: Tests - Test B: Dry heat
EN 61032:1998	Protection of persons and equipment by enclosures - Probes for verification
IEC 60598-1:2014+AMD1:2017 CSV	Luminaires - Part 1: General requirements and tests
EN 60664-1:2007	Insulation coordination for equipment within low-voltage systems - Part 1: Principles, requirements and tests
ISO 5893:2002	Rubber and plastics test equipment Tensile, flexural and compression types (constant rate of traverse) Specification
EN 61140:2016	Protection against electric shock - Common aspects for installation and equipment
IEC 60068-2-1:2007	Environmental testing - Part 2-1: Tests - Test A: Cold
EN 61010-1:2010	Safety requirements for electrical equipment for measurement, control, and laboratory use - Part 1: General requirements
ISO 4046-4:2002	Paper, board, pulps and related terms Vocabulary Part 4: Paper and board grades and converted products
IEC 60060-1:2010	High-voltage test techniques - Part 1: General definitions and test requirements
EN 62790:2015	Junction boxes for photovoltaic modules - Safety requirements and tests
IEC 61140:2016	Protection against electric shock - Common aspects for installation and equipment
IEC 61032:1997	Protection of persons and equipment by enclosures - Probes for verification
IEC 60695-2-10:2013	Fire hazard testing - Part 2-10: Glowing/hot-wire based test methods - Glow-wire apparatus and common test procedure
IEC 61010-1:2010+AMD1:2016 CSV	Safety requirements for electrical equipment for measurement, control, and laboratory use - Part 1: General requirements
IEC 60904-2 : 3.0EN+(REDLINE+VERSION)	PHOTOVOLTAIC DEVICES - PART 2: REQUIREMENTS FOR PHOTOVOLTAIC REFERENCE DEVICES
IEC 60664-1:2007	Insulation coordination for equipment within low-voltage systems - Part 1: Principles, requirements and tests
EN ISO 11925-2:2010/AC:2011	REACTION TO FIRE TESTS - IGNITABILITY OF PRODUCTS SUBJECTED TO DIRECT IMPINGEMENT OF FLAME - PART 2: SINGLE-FLAME SOURCE TEST