HEAT-SHRINKABLE LOW AND MEDIUM VOLTAGE MOULDED SHAPES - PART 3: SPECIFICATION FOR INDIVIDUAL MATERIALS - SHEET 101: HEAT-SHRINKABLE, POLYOLEFIN MOULDED SHAPES FOR LOW VOLTAGE APPLICATIONS

Published date

04-24-2018

Publisher

National Standards Authority of Ireland

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

National Foreword
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Designation
5 Conditions of test for dimensions
6 Requirements
7 Moulded shapes material conformance
Annex A (informative) - Adhesive compatibility guide
Bibliography
Annex ZA (normative) - Normative references to
international publications with their
corresponding European publications

Pertains to heat shrinkable low voltage moulded shapes in a range of configurations suitable for insulation, environmental sealing, mechanical protection, strain relief for power cable terminations, joints and stop ends.

DevelopmentNote	For CENELEC adoptions of IEC publication, please check www.iec.ch to be sure that you have any corrigenda that may apply. (04/2018)
DocumentType	Standard
PublisherName	National Standards Authority of Ireland
Status	Current

Standards	Relationship
EN IEC 62677-3-101:2018	Identical

IEC 62677-2:2017	Heat shrinkable low and medium voltage moulded shapes - Part 2: Methods of test
IEC 60502-1:2004+AMD1:2009 CSV	Power cables with extruded insulation and their accessories for rated voltages from 1 kV (<em>U</em><sub>m</sub> = 1,2 kV) up to 30 kV(<em>U</em><sub>m</sub> = 36 kV) - Part 1: Cables for rated voltages of 1 kV (<em>U</em><sub>m</sub> = 1,2 kV) and 3 kV (<em>U</em><sub>m</sub> = 3,6 kV)
IEC 62677-1:2017	Heat shrinkable low and medium voltage moulded shapes - Part 1: General requirements
ISO 846:1997	Plastics Evaluation of the action of microorganisms
IEC 60757:1983	Code for designation of colours
HD 457 : 200S1	CODE FOR DESIGNATION OF COLOURS
IEC 60296:2012 RLV	Fluids for electrotechnical applications - Unused mineral insulating oils for transformers and switchgear
EN 60296:2012	Fluids for electrotechnical applications - Unused mineral insulating oils for transformers and switchgear
EN ISO 846 : 1997	PLASTICS - EVALUATION OF THE ACTION OF MICROORGANISMS
IEC 60684-3-247:2011+AMD1:2016 CSV	Flexible insulating sleeving - Part 3 Specifications for individual types of sleeving - Sheet 247: Heatshrinkable, polyolefin sleeving, dual wall, not flame retarded, thick and medium wall
IEC 60684-3-214:2013	Flexible insulating sleeving - Part 3: Specifications for individual types of sleeving - Sheet 214: Heat-shrinkable, polyolefin sleeving, not flame retarded, thick and medium wall
EN ISO 868:2003	Plastics and ebonite - Determination of indentation hardness by means of a durometer (Shore hardness) (ISO 868:2003)
EN 50393:2015	Test methods and requirements for accessories for use on distribution cables of rated voltage 0,6/1,0 (1,2) kV
ISO 868:2003	Plastics and ebonite — Determination of indentation hardness by means of a durometer (Shore hardness)