MEASURING SYSTEMS FOR THE MASS OF LIQUIDS IN TANKS

Published date

01-12-2013

Publisher

Organisation Internationale de Metrologie Legale

Foreword
Terminology
Section I - General
Section II - Metrological Requirements
Section III - Technical Requirements
Section IV - Practical Installation Requirements
Section V - Metrological Controls
Annex A (Mandatory) - Performance tests and examinations
under laboratory simulated conditions
Annex B (Mandatory) - Performance tests under field conditions
Annex C (Informative) - Air buoyancy correction
Annex D (Informative) - Calculation of the minimum quantity
Annex E (Informative) - Diagrams showing common measuring
principles used
Annex F (Informative) - Alphabetical list of terminology
Bibliography

Describes the metrological and technical requirements for the pattern approval and verification of instruments used to determine the mass of liquid contained in a tank using methods which measure mass-related properties of the liquid while it is in a static state, e.g. the hydrostatic pressure of the liquid and gases in the tank.

Committee	TC 8/SC 2
DocumentType	Standard
PublisherName	Organisation Internationale de Metrologie Legale
Status	Current

Standards	Relationship
SANS 319 : 1.01ED 2011(R2016)	Identical
SANS 319:2011(R2022)	Identical

ISO 1155:1978	Information processing Use of longitudinal parity to detect errors in information messages
IEC 61000-4-4 : 3.0EN+(REDLINE+VERSION)	ELECTROMAGNETIC COMPATIBILITY (EMC) - PART 4-4: TESTING AND MEASUREMENT TECHNIQUES - ELECTRICAL FAST TRANSIENT/BURST IMMUNITY TEST
IEC 60068-3-1:2011	Environmental testing - Part 3-1: Supporting documentation and guidance - Cold and dry heat tests
IEC 61000-4-11:2004+AMD1:2017 CSV	Electromagnetic compatibility (EMC) - Part 4-11: Testing and measurement techniques - Voltage dips, short interruptions and voltage variations immunity tests
ISO 11223-1:1995	Petroleum and liquid petroleum products Direct static measurements Contents of vertical storage tanks Part 1: Mass measurement by hydrostatic tank gauging
ISO/IEC Guide 99:2007	International vocabulary of metrology Basic and general concepts and associated terms (VIM)
IEC 60068-2-3:1969	Basic environmental testing procedures - Part 2-3: Tests - Test Ca: Damp heat, steady state
ISO 2111:1985	Data communication Basic mode control procedures Code independent information transfer
IEC 60068-2-2:2007	Environmental testing - Part 2-2: Tests - Test B: Dry heat
IEC 61000-4-2:2008	Electromagnetic compatibility (EMC) - Part 4-2: Testing and measurement techniques - Electrostatic discharge immunity test
IEC 61000-4-3:2006+AMD1:2007+AMD2:2010 CSV	Electromagnetic compatibility (EMC) - Part 4-3: Testing and measurement techniques - Radiated, radio-frequency, electromagnetic field immunity test
IEC 60068-2-28:1990	Environmental testing - Part 2: Tests. Guidance for damp heat tests
IEC 60068-2-1:2007	Environmental testing - Part 2-1: Tests - Test A: Cold
IEC 60068-2-56:1988	Environmental testing - Part 2: Tests. Test Cb: Damp heat, steady state, primarily for equipment
IEC 60068-2-30:2005	Environmental testing - Part 2-30: Tests - Test Db: Damp heat, cyclic (12 h + 12 h cycle)