PREN 50134-2 : DRAFT 2016

Superseded

ALARM SYSTEMS - SOCIAL ALARM SYSTEMS - PART 2: TRIGGER DEVICES

Superseded date

11-01-2017

Published date

05-16-2016

Publisher

European Committee for Standards - Electrical

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Test of manually activated trigger devices
Annex A (normative) - Measurements of contact and insulation
resistances for mechanical contact function
Annex B (normative) - Strain relief test jig
Annex C (normative) - Test set-up by using rf-shielded
test fixtures
Bibliography

Describes the requirements for manually and automatically activated trigger devices transmitting a triggering signal.

Committee	TC 79
DocumentType	Draft
PublisherName	European Committee for Standards - Electrical
Status	Superseded

Standards	Relationship
16/30331025 DC : 0	Identical

IEC 61020-1:2009	Electromechanical switches for use in electrical and electronic equipment - Part 1: Generic specification
EN 50134-5:2004	Alarm systems - Social alarm systems - Part 5: Interconnections and communications
EN 50055:1998	Electrical apparatus for the detection and measurement of combustible gases - Performance requirements for Group I apparatus indicating up to 5 % (v/v) methane in air
EN 61020-1:2009	Electromechanical switches for use in electrical and electronic equipment - Part 1: Generic specification
IEC 61779-2:1998	Electrical apparatus for the detection and measurement of flammable gases - Part 2: Performance requirements for group I apparatus indicating a volume fraction up to 5 % methane in air
EN 50134-1:2002	Alarm systems - Social alarm systems - Part 1: System requirements
EN 50057:1998	Electrical apparatus for the detection and measurement of combustible gases - Performance requirements for Group II apparatus indicating up to 100 % lower explosive limit
IEC 62599-1:2010	Alarm systems - Part 1: Environmental test methods
EN 60447:2004	Basic and safety principles for man-machine interface, marking and identification - Actuating principles
IEC 61779-4:1998	Electrical apparatus for the detection and measurement of flammable gases - Part 4: Performance requirements for group II apparatus indicating up to 100% lower explosive limit
EN 303 131 : 1.1.0 DRAFT	ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); SHORT RANGE DEVICES; WIRELESS ALARMS WITH LOW DUTY CYCLE; HARMONIZED EN COVERING THE ESSENTIAL REQUIREMENTS OF ARTICLE 3.2 OF THE R&TTE DIRECTIVE
IEC 62599-2:2010	Alarm systems - Part 2: Electromagnetic compatibility - Immunity requirements for components of fire and security alarm systems
IEC 61779-3:1998	Electrical apparatus for the detection and measurement of flammable gases - Part 3: Performance requirements for group I apparatus indicating a volume fraction up to 100 % methane in air
IEC 60477:1974	Laboratory d.c. resistors
IEC 61779-5:1998	Electrical apparatus for the detection and measurement of flammable gases - Part 5: Performance requirements for group II apparatus indicating a volume fraction up to 100 % gas
EN 50056:1998	Electrical apparatus for the detection and measurement of combustible gases - Performance requirements for Group I apparatus indicating up to 100 % (v/v) methane in air