INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
   7.1 Items to be marked
   7.2 Durability and legibility of marking
8 Terminals
9 Provisions for protective earthing
10 Protection against accidental contact with live
   parts
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings of ballasts
14 Fault conditions
15 Construction
   15.1 Wood, cotton, silk, paper and similar fibrous
        material
   15.2 Printed circuits
16 Creepage distances and clearances
17 Screws, current-carrying parts and connections
18 Resistance to heat, fire and tracking
19 Resistance to corrosion
Annex A (normative) Test to establish whether a
         conductive part is a live part, which may
         cause an electric shock
Annex B (normative) Particular requirements for
         thermally protected lamp controlgear
Annex C (normative) Particular requirements for
         electronic lamp controlgear with means of
         protection against overheating
Annex D (normative) Requirements for carrying out the
         heating tests of thermally protected lamp
         controlgear
Annex E (normative) Use of constant S other than 4500
         in t[w] tests
Annex F (normative) Draught-proof enclosure
Annex G (normative) Explanation of the derivation of
         the values of pulse voltages
Annex H (normative) Tests
Annex ZA (normative) Normative references to
         international publications with their
         corresponding European publications
Bibliography