INFORMATION TECHNOLOGY - SERIAL STORAGE ARCHITECTURE - PHYSICAL LAYER 2 (SSA-PH2)

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-01-2007

Publisher

Information Technology Industry Council

Foreword
Introduction
1 Scope
  1.1 SSA-PH2 characteristics
  1.2 SSA family of standards
2 References
  2.1 Normative references
  2.2 Informative references
3 Definitions, symbols, and abbreviations
  3.1 Definitions
  3.2 Symbols and abbreviations
4 Conventions
5 Modulation
6 Data Rate
7 Electrical requirements
  7.1 Line driver
  7.2 Line receiver
  7.3 Line segment termination
  7.4 Ground shift
  7.5 Port connection
  7.6 System level noise margin
8 Interconnections
  8.1 Internal connectors
  8.2 Internal Port Connections
  8.3 Internal options bay connections
  8.4 Internal device power connections
  8.5 External connections
Annexes
Annex A (normative) Transfer impedance testing procedure
Annex B (normative) Internal connector testing procedure
Annex C (normative) External micro-miniature D connector
        testing procedure
Annex D (normative) External HSSDC connector testing procedure
Annex E (normative) Nulling of intersymbol jitter
Annex F (informative) Line fault detection scheme example
Annex G (informative) Circuit for degrading signal amplitude
        and introducing 85 common mode levels
Annex H (informative) Preferred test configurations for SSA
        links
Annex I (informative) Implementation guidelines
Annex J (informative) Reference for copper, polymer dielectric,
        non-equalized SSA Cable Assemblies
Annex K (informative) The use of fiberoptic Port Connection
        Couplers with SSA

Delineates the SSA physical layer 2 of the Serial Storage Architecture (SSA). SSA defines a serial interface hierarchy to be used for purposes within its distance and performance characteristics, including but not limited to storage subsystems.

Committee	X3T10
DocumentType	Standard
Pages	106
ProductNote	Reconfirmed 2007
PublisherName	Information Technology Industry Council
Status	Current
Supersedes	ANSI INCITS 307 : 1997 : R2002

IEC 60512-11-7:2003	Connectors for electronic equipment - Tests and measurements - Part 11-7: Climatic tests - Test 11g: Flowing mixed gas corrosion test
EN 50082-1:1997	Electromagnetic compatibility - Generic immunity standard - Part 1: Residential, commercial and light industry