AS 4032.2-2005

The objective of this Standard is to provide manufacturers with requirements for tempering valves and end-of-line temperature-actuated devices that give reasonable protection to users against exposure to high or excessive fluctuations in mixed water temperatures caused by the following: - Maintaining an outlet temperature within specified limits, including shut-off of the cold water supply. - Closing the outlet when the mixed water temperature exceeds a specified maximum.

This Standard specifies requirements for the design, construction, testing and performance of - (a) tempering valves of nominal sizes not larger than DN32; and(b) end-of-line temperature-actuated devices of nominal size not larger than DN25,for use with heated water at - (i) continuous operating temperature not exceeding 85°C;(ii) temperature under emergency conditions, not exceeding 99°C; and(iii) continuous working pressure not exceeding 1400kPa.Devices complying with this Standard are intended to prevent a continuous discharge of water from the outlet in excess of 50°C under steady-state conditions.Transient discharges of water with a temperature in excess of this figure, which comply with the specified cumulative time/temperature factors, are acceptable.NOTE: Tempering valves, when adjusted to an outlet temperature not exceeding 50°C, and end-of-line devices may be used for temperature-limiting for ablution purposes, to minimize the risk of scalding, other than for use in health care, aged care, child care, care for people with disabilities and any other at-risk situations. Thermostatic mixing valves complying with AS4032.1, when adjusted to an outlet temperature not exceeding 45°C, are intended for use in health care, aged care, child care, care for people with disabilities and any other at-risk situations.

First published as AS4032.2-2002.Second Edition 2005. Originated as AS 4032.2-2002. Second Edition 2005. Reissued incorporating Amendment No. 1 (October 2006). Reissued incorporating Amendment No. 2 (June 2009).