• There are no items in your cart

AS/NZS 7000:2010

AvailableSuperseded
AvailableSuperseded

An Available Superseded Standard is one, which has been made available for a period of time although it has been formally superseded by another Standard. Its availability is maintained where it is referenced in legislation/regulations or in other Standards and its use should be restricted to where so referenced. No responsibility is taken by Intertek Inform as to the ongoing technical validity of such a Standard, the responsibility resting with the referencing authority.

Overhead line design - Detailed procedures
Available format(s)

Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users

Language(s)

English

Published date

11-26-2010

Preview

Provides requirements, methods and guidance for the design and construction of overhead electrical power lines. It applies to alternating current lines operating at a nominal frequency of 50 Hz.

This Standard specifies the general requirements that shall be met for the design and construction of new overhead lines to ensure that the line is suitable for its intended purpose, and provides acceptable levels of safety for construction, maintenance and operation, and meets requirements for environmental considerations.This Standard is only applicable to new overhead lines and is not intended to be retrospectively applied to the routine maintenance, and ongoing life extension of existing overhead lines constructed prior to the issue of this Standard. Such maintenance and life extension work ensures that lines continue to comply with the original design standards and remain safe and ‘fit for purpose’.However, where existing overhead lines are proposed to be altered such that elements of the overhead line may be overloaded or overstressed to the original design standard; then the overhead line shall be required to be assessed by a competent person for compliance with the provisions of this Standard.This Standard is applicable to overhead lines supporting telecommunication systems or where they are used on overhead lines either attached to the aerial line conductor/earth wire systems or as separate cables supported by the supports. These telecommunication systems include optical ground wires (OPGWs), optical conductors and all dielectric self supporting (ADSS) cables. It is also applicable to overhead line structures supporting telecommunications equipment. The electrical requirements of this standard apply to alternating current (a.c.) systems with a nominal frequency of 50 Hz.This Standard does not apply to catenary systems of electrified railways.

Committee
EL-052
DocumentType
Standard
ISBN
978 0 7337 9728 6
Pages
291
PublisherName
Standards Australia
Status
AvailableSuperseded
SupersededBy
Supersedes
UnderRevision

First published as AS/NZS 7000:2010.

AS 1604.1-2010 Specification for preservative treatment Sawn and round timber
AS 2560.2.3-2007 Sports lighting Specific applications - Lighting for football (all codes) (Reconfirmed 2017)
AS/NZS 4058:2007 Precast concrete pipes (pressure and non-pressure)
AS 1720.1-2010 Timber structures Design methods
AS/NZS 4853:2000 Electrical hazards on metallic pipelines
AS/NZS 4680:2006 Hot-dip galvanized (zinc) coatings on fabricated ferrous articles (Reconfirmed 2017)
AS/NZS 3560.1:2000 Electric cables - Cross-linked polyethylene insulated - Aerial bundled - For working voltages up to and including 0.6/1(1.2) kV Aluminium conductors (Reconfirmed 2021)
AS/NZS 1768:2007 Lightning protection
AS 60305-2007 Insulators for overhead lines with a nominal voltage above 1000 V - Ceramic or glass insulator units for a.c. systems - Characteristics of insulator units of the cap and pin type
AS 2560.2.8-2007 Sports lighting Specific applications - Outdoor bowling greens (Reconfirmed 2017)
AS 2560.2.4-1986 Guide to sports lighting Lighting for outdoor netball and basketball (Reconfirmed 2017)
HB 101-1997 (CJC 5) Coordination of power and telecommunications - Low Frequency Induction (LFI) - Code of practice for the mitigation of hazardous voltages induced into telecommunications lines
AS/NZS 3835.2:2006 Earth potential rise - Protection of telecommunications network users, personnel and plant Application guide
AS 2067-2008 Substations and high voltage installations exceeding 1 kV a.c.
AS/NZS 2947.1:1999 Insulators - Porcelain and glass for overhead power lines - Voltages greater than 1000 V a.c. Test methods - Insulator units
ENA NENS 04-2006 National guidelines for safe approach distances to electrical and mechanical apparatus
AS 4435.1-1996 Insulators - Composite for overhead lines - Voltages greater than 1000 V a.c. Definitions, test methods and acceptance criteria for string insulator units
AS ISO 13822-2005 Basis for design of structures - Assessment of existing structures (ISO 13822:2001, MOD)
AS 2560.2.7-1994 Guide to sports lighting Specific recommendations - Outdoor hockey (Reconfirmed 2017)
AS/NZS 60479.1:2010 Effects of current on human beings and livestock General aspects
AS 1012.11-2000 Methods of testing concrete Determination of the modulus of rupture (Reconfirmed 2014)
AS/NZS 3560.2:2003 Electric cables - Cross-linked polyethylene insulated - Aerial bundled - For working voltages up to and including 0.6/1 (1.2) kV Copper conductors
AS/NZS 4676:2000 Structural design requirements for utility services poles
AS/NZS 2344:1997 Limits of electromagnetic interference from overhead a.c. powerlines and high voltage equipment installations in the frequency range 0.15 to 1000 MHz
AS 4436-1996 Guide for the selection of insulators in respect of polluted conditions
AS 1657-1992 Fixed platforms, walkways, stairways and ladders - Design, construction and installation
AS 2209-1994 Timber - Poles for overhead lines
AS 6947-2009 Crossing of waterways by electricity infrastructure (Reconfirmed 2019)
AS 1154.1-2009 Insulator and conductor fittings for overhead power lines Performance, material, general requirements and dimensions (Reconfirmed 2019)
AS/NZS 1891.2:2001 Industrial fall-arrest systems and devices Horizontal lifeline and rail systems
SAA HB 88-1997 (CJC 2) Unbalanced high voltage power lines - Code of practice for the mitigation of noise induced into paired cable telecommunications lines from unbalanced high voltage power lines
AS 1170.4-2007 Structural design actions Earthquake actions in Australia (Reconfirmed 2018)
AS/NZS 1170.0:2002 Structural design actions General principles
AS/NZS 3599.2:1999 Electric cables - Aerial bundled - Polymeric insulated - Voltages 6.35/11(12) kV and 12.7/22(24) kV Non-metallic screened
AS 4398.2-2005 Insulators - Ceramic or glass - Station post for indoor or outdoor use - Voltages greater than 1000 V a.c. Tests (IEC 60168, Ed. 4.2 (2001) MOD)
AS 2560.2.2-1986 Guide to sports lighting Lighting of multipurpose indoor sports centres (Reconfirmed 2017)
AS 3600-2009 Concrete structures
AS 4100 SUPP 1-1999 Steel structures - Commentary (Supplement to AS 4100-1998)
AS/NZS 4600 SUPP 1:1998 Cold-formed steel structures - Commentary (Supplement to AS/NZS 4600:1996)
AS 1746-1991 Conductors - Bare overhead - Hard-drawn copper
AS 1222.1-1992 Steel conductors and stays - Bare overhead Galvanized (SC/GZ) (Reconfirmed 2016)
AS/NZS 2312:2002 Guide to the protection of structural steel against atmospheric corrosion by the use of protective coatings
AS 2560.1-2002 Sports lighting General principles
AS 1726-1993 Geotechnical site investigations
AS 3607-1989 Conductors - Bare overhead, aluminium and aluminium alloy - Steel reinforced (Reconfirmed 2016)
AS/NZS 1891.1:2007 Industrial fall-arrest systems and devices Harnesses and ancillary equipment
AS/NZS 1891.3:1997 Industrial fall-arrest systems and devices - Fall-arrest devices
AS 2560.2.1-2003 Sports lighting Specific applications - Lighting for outdoor tennis (Reconfirmed 2017)
AS/NZS 1559:1997 Hot-dip galvanized steel bolts and associated nuts and washers for tower construction
AS 1289.6.3.1-2004 Methods of testing soils for engineering purposes Soil strength and consolidation tests - Determination of the penetration resistance of a soil - Standard penetration test (SPT) (Reconfirmed 2016)
AS 4398.1-1996 Insulators - Ceramic or glass - Station post for indoor and outdoor use - Voltages greater than 1000 V a.c. Characteristics (Reconfirmed 2016)
AS/NZS 3599.1:2003 Electric cables - Aerial bundled - Polymeric insulated - Voltages 6.35/11 (12) kV and 12.7/22 (24) kV Metallic screened (Reconfirmed 2021)
AS 2159-2009 Piling - Design and installation
AS 3609-2005 Insulators - Porcelain stay type - Voltages greater than 1000 V a.c.
AS/NZS 4065:2010 Concrete utility services poles
AS 4435.4-2005 Insulators - Composite for overhead power lines - Voltages greater than 1000 V a.c. Definitions, test methods, acceptance criteria for post insulator units (Reconfirmed 2016)
AS/NZS 3835.1:2006 Earth potential rise - Protection of telecommunications network users, personnel and plant Code of practice
AS 1222.2-1992 Steel conductors and stays - Bare overhead Aluminium clad (SC/AC) (Reconfirmed 2016)
AS 2560.2.6-1994 Guide to sports lighting Specific recommendations - Baseball and softball (Reconfirmed 2017)
AS/NZS 1891.4:2009 Industrial fall-arrest systems and devices Selection, use and maintenance
AS/NZS 1252:1996 High-strength steel bolts with associated nuts and washers for structural engineering
AS 1798-1992 Lighting poles and bracket arms - Preferred dimensions
AS/NZS 4435.2:1999 Insulators - Composite for overhead power lines - Voltages greater than 1000 V a.c. Standard strength classes and end fittings for string insulator units (Reconfirmed 2016)
AS/NZS 4600:2005 Cold-formed steel structures
AS 3608-2005 Insulators - Porcelain and glass, pin and shackle type - Voltages not exceeding 1000 V a.c.
AS/NZS 2373:2003 Electric cables - Twisted pair for control and protection circuits (Reconfirmed 2017)
AS/NZS 3675:2002 Conductors - Covered overhead - For working voltages 6.35/11 (12) kV up to and including 19/33 (36) kV (Reconfirmed 2017)
AS 1824.2-1985 Insulation coordination (phase-to-earth and phase-to-phase, above 1 kV) - Application guide
AS 2979-1998 Traffic signal mast arms
AS 2159 SUPP 1-1996 Piling - Design and installation - Guidelines (Supplement to AS 2159 - 1995) (Reconfirmed 2018)
AS 1170.4 SUPP 1-1993 Minimum design loads on structures (known as the SAA Loading Code) Earthquake loads - Commentary (Supplement to AS 1170.4-1993)
AS/NZS 4677:2010 Steel utility services poles
AS 4100-1998 Steel structures (Reconfirmed 2016)
AS 1531-1991 Conductors - Bare overhead - Aluminium and aluminium alloy (Reconfirmed 2016)
AS 1720.2-2006 Timber structures Timber properties
AS/NZS 1170.1:2002 Structural design actions Permanent, imposed and other actions
AS 3995-1994 Design of steel lattice towers and masts
AS 1154.3-2009 Insulator and conductor fittings for overhead power lines Performance and general requirements for helical fittings (Reconfirmed 2019)
AS 2650-2005 Common specifications for high-voltage switchgear and controlgear standards (IEC 60694 Ed.2.2(2002) MOD)
AS 2560.2.5-2007 Sports lighting Specific applications - Swimming pools (Reconfirmed 2017)
AS 3822-2002 Test methods for bare overhead conductors
AS 3600 SUPP 1-1994 Concrete structures - Commentary (Supplement to AS 3600-1994)
AS/NZS 1170.2:2002 Structural design actions Wind actions
AS/NZS 2947.4:1999 Insulators - Porcelain and glass for overhead power lines - Voltages greater than 1000 V a.c. Test methods - Insulator strings and insulator sets
AS/NZS 1328.1:1998 Glued laminated structural timber Performance requirements and minimum production requirements

HB 331-2012 Overhead line design
AS/NZS 3007:2013 Electrical equipment in mines and quarries - Surface installations and associated processing plant

View more information
US$199.05
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.