Foreword
Committee Roster
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Environmental and metrological requirements
  5.1 Environmental conditions
  5.2 Operating conditions
  5.3 Length measurement error, E[L]
  5.4 Repeatability range of the length measurement error, R[0]
  5.5 Workpiece loading effects
6 Acceptance tests and reverification tests
  6.1 General
  6.2 Principle
  6.3 Length measurement error with zero ram axis stylus tip
      offset, E[0]
      6.3.1 General
      6.3.2 Measuring equipment
      6.3.3 Procedure
      6.3.4 Derivation of test results
  6.4 Repeatability range of the length measurement error, R[0]
  6.5 Length measurement error with ram axis stylus tip offset of
      length 150 mm, E[150]
      6.5.1 Measuring equipment
      6.5.2 Procedure
      6.5.3 Derivation of test results
  6.6 Dual ram CMMs
      6.6.1 Simplex operating mode
      6.6.2 Duplex operating mode
7 Compliance with specifications
  7.1 Acceptance test
      7.1.1 Acceptance criteria
      7.1.2 Data rejection and repeated measurements
      7.1.3 Thermal derating of specifications
  7.2 Reverification test
8 Applications
  8.1 Acceptance test
  8.2 Reverification test
  8.3 Interim check
9 Indication in product documentation and data sheets
Annex A (informative) - Interim check
A.1 Interim check of the CMM
A.2 Interim testing and the comparison to specifications
    A.2.1 General
    A.2.2 Interim testing using uni-directional artefacts
Annex B (normative) - Artefacts that represent a calibrated test
                      length
B.1 General
B.2 Bi-directional measurements
    B.2.1 General
    B.2.2 Gauge blocks
    B.2.3 Step gauges measured in a bi-directional manner
    B.2.4 Ball bars/ball plates measured in a bi-directional manner
    B.2.5 Laser interferometry with contact probing measured in a
          bi-directional manner
B.3 Uni-directional measurements (must be supplemented with
    bi-directional measurements)
    B.3.1 General
    B.3.2 Calibrated test length composed of uni-directional and
          short gauge block measurements
    B.3.3 Artefacts for uni-directional measurements
Annex C (informative) - Alignment of gauges
C.1 General
C.2 Parallel face gauges
C.3 Ball bar/ball plate gauges
Annex D (normative) - Mathematical adjustments to Low CTE artefacts
D.1 General
D.2 Requirements
Annex E (normative) - Test uncertainty
Annex F (normative) - Traceability of calibrated test lengths
Annex G (normative) - Decision rule for conformance testing
Annex H (informative) - Interim testing of CMM systems
Annex I (normative) - ASME B89.4.10360.2 Data sheet
Annex J (informative) - Figures 12, 13 and 14 from ISO 10360-1:2000
Bibliography