• There are no items in your cart

ASTM A 985/A985M : 2018 : REV A

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Specification for Steel Investment Castings General Requirements, for Pressure-Containing Parts
Available format(s)

Hardcopy , PDF

Superseded date

03-13-2019

Language(s)

English

Published date

09-01-2018

1.1 This specification covers a group of common requirements that are mandatory for steel castings produced by the investment casting process for pressure-containing parts under each of the following ASTM Specifications:

1.1This specification covers a group of common requirements that are mandatory for steel castings produced by the investment casting process for pressure-containing parts under each of the following ASTM Specifications:

Title of Specification

ASTM Designation

Steel Castings, Carbon, Suitable for Fusion Welding,

A216/A216M

for High-Temperature Service

Steel Castings, Martensitic Stainless and Alloy, for

A217/A217M

Pressure-Containing Parts, Suitable for High-

Temperature Service

Castings, Austenitic, for Pressure-Containing

A351/A351M

Parts

Steel Castings, Ferritic and Martensitic, for Pressure-

A352/A352M

Containing Parts, Suitable for Low-Temperature

Service

Steel Castings, Alloy, Specially Heat-Treated, for

A389/A389M

Pressure-Containing Parts, Suitable for High-

Temperature Service

Steel Castings Suitable for Pressure Service

A487/A487M

Castings, Iron-Nickel-Chromium and Nickel Alloys, Spe-
     cially Controlled for Pressure-Retaining Parts for
     Corrosive Service

A990/A990M

Castings, Austenitic-Ferritic (Duplex) Stainless Steel, for
     Pressure-Containing Parts

A995/A995M

1.2This specification also covers a group of supplementary requirements, which may be applied to the above specifications as indicated therein. These requirements are provided for use when additional testing or inspection is desired, and apply only when specified individually by the purchaser in the order.

1.3When investment casting is ordered, the requirements of this specification shall take precedence over the individual material specification requirements.

1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee
A 01
DocumentType
Standard
Pages
11
ProductNote
THIS STANDARD ALSO REFERS TO A351/A351M , B16.5 , ASME 2546
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

View more information
US$83.00
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.