Standard Specification for Copper-Beryllium Alloy Rod and Bar

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

04-12-2018

Publisher

American Society for Testing and Materials

This specification establishes the requirements for copper-beryllium alloy rod and bar in straight lengths.

1.1This specification establishes the requirements for copper-beryllium alloy rod and bar in straight lengths. The following three alloys are included:

Copper Alloy UNS No.	Previously Used Designations	Nominal Beryllium Content, %

C17000	Alloy 165	1.7
C17200	Alloy 25	1.9
C17300		1.9
		+0.4 lead

1.2Unless otherwise required, Copper Alloy UNS No. C17200 shall be the alloy furnished whenever Specification B196/B196M is specified without any alloy designation.

1.3The values stated in either inch-pounds or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	B 05
DocumentType	Standard
Pages	5
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM B 196/B196M : 2007 : R2013 : EDT 1

ASTM E 8/E8M : 2024	Standard Test Methods for Tension Testing of Metallic Materials
ASTM E 8/E8M : 2016 : REV A : EDT 1	Standard Test Methods for Tension Testing of Metallic Materials
ASTM E 8/E8M : 2021	Standard Test Methods for Tension Testing of Metallic Materials
ASTM B 194 : 2022	Standard Specification for Copper-Beryllium Alloy Plate, Sheet, Strip, and Rolled Bar
ASTM E 8/E8M : 2022	Standard Test Methods for Tension Testing of Metallic Materials
ASTM B 249/B249M : 2023	Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings
ASTM B 249/B249M : 2022	Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings
ASTM B 249/B249M : 2020	Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings
ASTM B 194 : 2015	Standard Specification for Copper-Beryllium Alloy Plate, Sheet, Strip, and Rolled Bar