ASTM B 610 : 2000 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Test Method for Measuring Dimensional Changes of Metal Powder Specimens
Hardcopy , PDF
11-11-2014
English
04-10-2000
1.1 This test method covers a procedure for determining the change in dimensions that occurs as a result of sintering a metal powder specimen. The size change referred to is the difference between the die size and the size of the sintered specimen after it has cooled to room temperature, expressed as a percentage. This size change is a basic characteristic of the metal powder.
1.2 The general procedure of measuring a test specimen and die, the calculating he dimensional changes, as described in this test method, also may be used to determine green expansion, heat treat changes, or other dimensional changes of test specimens that result from processing steps.
1.3 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents are in parentheses and may be approximate.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.