Standard Test Method for Sieve Analysis of Fine and Coarse Aggregates

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

12-01-2019

Publisher

American Society for Testing and Materials

1.1This test method covers the determination of the particle size distribution of fine and coarse aggregates by sieving.

1.2Some specifications for aggregates which reference this test method contain grading requirements including both coarse and fine fractions. Instructions are included for sieve analysis of such aggregates.

1.3Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Note 1:Sieve size is identified by its standard designation in Specification E11. The alternative designation given in parentheses is for information only and does not represent a different standard sieve size. Specification E11 cites the following with respect to SI units versus inch-pound units as standard. “The values stated in SI units shall be considered standard for the dimensions of the sieve cloth openings and the wire diameters used in the sieve cloth. The values stated in inch-pound units shall be considered standard with regard to the sieve frames, pans,” and covers.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	C 09
DocumentType	Test Method
Pages	5
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM C 136/C136M : 2014

ACI SPEC-548.10:2022

Type Methyl Methacrylate Slurry (MMS) Polymer Overlays for Bridge and Parking Garage Deck— Specification

ASTM C 125 : 2021	Standard Terminology Relating to Concrete and Concrete Aggregates
ASTM E 11 : 2020	Standard Specification for Woven Wire Test Sieve Cloth and Test Sieves
ASTM C 117 : 2017	Standard Test Method for Materials Finer than 75-μm (No. 200) Sieve in Mineral Aggregates by Washing
ASTM C 670 : 2024	Standard Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials
ASTM C 125 : 2000	Standard Terminology Relating to Concrete and Concrete Aggregates
ASTM E 11 : 2022	Standard Specification for Woven Wire Test Sieve Cloth and Test Sieves
ASTM C 117 : 2023	Standard Test Method for Materials Finer than 75-μm (No. 200) Sieve in Mineral Aggregates by Washing
ASTM C 670 : 2024 : REV A	Standard Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials
ASTM C 125 : 2021 : REV A	Standard Terminology Relating to Concrete and Concrete Aggregates
ASTM C 125 : 2020	Standard Terminology Relating to Concrete and Concrete Aggregates
ASTM C 670 : 2015	Standard Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials
ASTM C 125 : 2009	Standard Terminology Relating to Concrete and Concrete Aggregates