• ASTM D 2802 : 2014 : REDLINE

    Current The latest, up-to-date edition.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You have already added this standard to your Watchlist.
    Visit My Watchlist to view the full list.

    Standard Specification for Ozone-Resistant Ethylene-Alkene Polymer Insulation for Wire and Cable

    Available format(s):  PDF

    Language(s):  English

    Published date:  11-01-2014

    Publisher:  American Society for Testing and Materials

    Add to Watchlist

    Add To Cart

    Abstract - (Show below) - (Hide below)

    CONTAINED IN VOL. 10.02, 2016 Defines an ozone-resisting crosslinked rubber insulation compound for electrical wires and cables.

    Scope - (Show below) - (Hide below)

    1.1This specification covers an ozone-resisting crosslinked rubber insulation compound for electrical wires and cables. The polymer shall consist substantially of ethylene-alkene copolymer (EAM) or ethylene-alkene diene terpolymer (EADM). This polymer type includes ethylenepropylene copolymer (EPM) and ethylenepropylene diene terpolymer (EPDM).

    1.2This type of insulation is considered suitable for use on wire or cable which will be used in wet and dry locations with conductor temperatures up to 90°C during continuous operation, to 130°C during emergency overload conditions, and to 250°C during short-circuit conditions. It is considered suitable for all sizes and voltage classifications of single- and multiple-conductor power cables up to 35 000 V phase-to-phase at the 100 % insulation level and up to 25 000 V at the 133 % insulation level as listed in Table 1D of Test Methods D470. Single-conductor cables shall have a supplementary covering over the insulation, and multiple-conductor cables shall have an overall covering.

    1.3Whenever two sets of values are presented, in different units, the values in the first set are the standard, while those in parentheses are for information only.

    1.4In many instances the insulation material cannot be tested unless it has been formed around a conductor or cable. Therefore, tests are done on insulated wire or cable in this specification solely to determine the relevant property of the insulation and not to test the conductor or completed cable.

    General Product Information - (Show below) - (Hide below)

    Committee D 09
    Document Type Redline
    Publisher American Society for Testing and Materials
    Status Current

    Standards Referenced By This Book - (Show below) - (Hide below)

    MIL DTL 16878 : H WIRE, ELECTRICAL, INSULATED, GENERAL SPECIFICATION FOR
    ASTM F 2321 : 2014 : REDLINE Standard Specification for Flexible and Rigid Insulated Temporary By-Pass Jumpers

    Standards Referencing This Book - (Show below) - (Hide below)

    ASTM D 1711 : 2015 : REDLINE Standard Terminology Relating to Electrical Insulation
    ICEA T 24 380 : 2013 PARTIAL DISCHARGE TEST PROCEDURE
    ASTM D 470 : 2013 : REDLINE Standard Test Methods for Crosslinked Insulations and Jackets for Wire and Cable
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective