• There are no items in your cart

ASTM D 3045 : 1992 : R2010

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Practice for Heat Aging of Plastics Without Load
Available format(s)

Hardcopy , PDF

Superseded date

11-03-2018

Language(s)

English

Published date

03-15-2010

CONTAINED IN VOL. 08.02, 2015 Describes the exposure conditions for testing the resistance of plastics to oxidation or other degradation when exposed solely to hot air for extended periods of time.

1.1 This practice is intended to define the exposure conditions for testing the resistance of plastics to oxidation or other degradation when exposed solely to hot air for extended periods of time. Only the procedure for heat exposure is specified, not the test method or specimen. The effect of heat on any particular property may be determined by selection of the appropriate test method and specimen.

1.2 This practice should be used as a guide to compare thermal aging characteristics of materials as measured by the change in some property of interest. This practice recommends procedures for comparing the thermal aging characteristics of materials at a single temperature. Recommended procedures for determining the thermal aging characteristics of a material at a series of temperatures for the purpose of estimating time to a defined property change at some lower temperature are also described.

1.3 This practice does not predict thermal aging characteristics where interactions between stress, environment, temperature, and time control failure occurs.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—ISO-2578 is considered to be technically equivalent to this practice.

Committee
D 20
DevelopmentNote
Supersedes ASTM D 3776. (08/2009)
DocumentType
Standard Practice
Pages
0
ProductNote
Reconfirmed 2010 Reconfirmed EDT 1
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy

ISO 2578:1993 Plastics Determination of time-temperature limits after prolonged exposure to heat
ASTM D 1870 : 1991 Practice for Elevated Temperature Aging Using a Tubular Oven (Withdrawn 1998)
ASTM D 618 : 2013 : REDLINE Standard Practice for Conditioning Plastics for Testing

View more information
US$75.00
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.