Standard Test Method for Resin Flow of Carbon Fiber-Epoxy Prepreg

Available format(s)

PDF

Language(s)

English

Published date

11-01-2016

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 15.03, 2016 Defines the determination of the amount of resin flow that will take place from prepreg tape or sheet under given conditions of temperature and pressure.

1.1This test method covers the determination of the amount of resin flow that will take place from prepreg tape or sheet under given conditions of temperature and pressure.

1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.2.1Within the text, inch-pound units are shown in brackets.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee	D 30
DevelopmentNote	Supersedes ASTM D 3531. (11/2011)
DocumentType	Redline
Pages	5
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 345 : 2002 ASTM D 3531 : 1999 : R2009 ASTM D 3531 : 1999 : R2004 ASTM D 3531 : 1999

SAE AMS 3970/1 : 2011	CARBON FIBER FABRIC REPAIR PREPREG, 120 DEGREES C (250 DEGREES F) VACUUM CURING - PART 1 - GENERAL REQUIREMENTS
SAE AMS 3970/4 : 2011	CARBON FIBER FABRIC REPAIR PREPREG, 120 DEGREES C (250 DEGREES F) VACUUM CURING - PART 4: PURCHASING SPECIFICATION FOR FILM ADHESIVE