Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

11-22-2023

Publisher

American Society for Testing and Materials

1.1This test method covers the determination of puncture properties of rigid plastics over a range of test velocities.

1.2Test data obtained by this test method are relevant and appropriate for use in engineering design.

1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1:This standard and ISO 6603-2 address the same subject matter, but differ in technical content. The technical content and results shall not be compared between the two test methods.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 20
DocumentType	Test Method
Pages	11
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 3763 : 2018

ASTM D 5628 : 2018	Standard Test Method for Impact Resistance of Flat, Rigid Plastic Specimens by Means of a Falling Dart (Tup or Falling Mass)
ASTM C 1349 : 2017	Standard Specification for Architectural Flat Glass Clad Polycarbonate
ASTM D 5857 : 2017	Standard Specification for Polypropylene Injection and Extrusion Materials Using ISO Protocol and Methodology
ASTM D 5420 : 2021	Standard Test Method for Impact Resistance of Flat, Rigid Plastic Specimen by Means of a Striker Impacted by a Falling Weight (Gardner Impact)
ASTM C 1484 : 2010 : R2018	Standard Specification for Vacuum Insulation Panels
ASTM D 7436 : 2017	Standard Classification System for Unfilled Polyethylene Plastics Molding and Extrusion Materials with a Fractional Melt Index Using ISO Protocol and Methodology
ASTM D 7136/D7136M : 2020	Standard Test Method for Measuring the Damage Resistance of a Fiber-Reinforced Polymer Matrix Composite to a Drop-Weight Impact Event
ASTM D 4000 : 2023	Standard Classification System for Specifying Plastic Materials
ASTM D 4101 : 2017 : EDT 1	Standard Classification System and Basis for Specification for Polypropylene Injection and Extrusion Materials

ASTM D 883 : 2023	Standard Terminology Relating to Plastics
ASTM D 883 : 2024	Standard Terminology Relating to Plastics
ASTM E 456 : 2013 : REV A : R2022	Standard Terminology Relating to Quality and Statistics
ASTM E 456 : 2013 : REV A : R2022 : EDT 1	Standard Terminology Relating to Quality and Statistics