• There are no items in your cart

ASTM D 5404/D5404M : 2012 : R2017

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator
Available format(s)

Hardcopy , PDF

Superseded date

11-11-2021

Language(s)

English

Published date

10-11-2017

CONTAINED IN VOL. 04.03, 2017 Defines asphalt from a solvent using the rotary evaporator to ensure that changes in the asphalt properties during the recovery process are minimized.

1.1This practice is intended to recover asphalt from a solvent using the rotary evaporator to ensure that changes in the asphalt properties during the recovery process are minimized.

1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.2.1Residual pressure measurements are shown in both the SI unit of kPa and the commonly used non-standard equivalent unit of “mm of Hg.”

1.2.2Measurements of volume and mass are only given in SI units because they are the only units typically used in practice when performing this standard practice.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee
D 04
DevelopmentNote
Supersedes ASTM D 5404. (04/2011)
DocumentType
Standard Practice
Pages
3
ProductNote
Reconfirmed 2017
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

ASTM D 2172/D2172M : 2017 : EDT 1 Standard Test Methods for Quantitative Extraction of Asphalt Binder from Asphalt Mixtures

ASTM D 6368 : 2006 : R2018 Standard Specification for Vapor-Degreasing Solvents Based on <emph type="bdit">normal</emph >-Propyl Bromide and Technical Grade <emph type="bdit">normal</emph >-Propyl Bromide
ASTM D 3666 : 2013 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 3666 : 2011 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 6368 : 2000 Standard Specification for Vapor-Degreasing Grade and General Grade <i>normal</i>-Propyl Bromide
ASTM D 3666 : 2007 : REV A Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 1856 : 2009 Standard Test Method for Recovery of Asphalt From Solution by Abson Method
ASTM D 3666 : 2016 : REDLINE Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 3666 : 2009 : REV A Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 6368 : 2005 Standard Specification for Vapor-Degreasing Grade and General Grade <bdit>normal</bdit>-Propyl Bromide
ASTM D 3666 : 2005 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 3666 : 2003 : REV A Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 6368 : 2002 Standard Specification for Vapor-Degreasing Grade and General Grade <i>normal</i>-Propyl Bromide
ASTM D 3666 : 2000 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 2939 : 2003 Standard Test Methods for Emulsified Bitumens Used as Protective Coatings (Withdrawn 2012)
ASTM D 1856 : 2021 Standard Test Method for Recovery of Asphalt from Solution by Abson Method
ASTM D 1856 : 1995 : REV A : R2003 Standard Test Method for Recovery of Asphalt From Solution by Abson Method
ASTM D 3666 : 2007 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 3666 : 2007 : EDT 2 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 3666 : 2016 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 1856 : 1995 : REV A Standard Test Method for Recovery of Asphalt From Solution by Abson Method
ASTM D 3666 : 2003 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 1856 : 2009 : R2015 Standard Test Method for Recovery of Asphalt From Solution by Abson Method
ASTM D 3666 : 2001 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 6368 : 2006 Standard Specification for Vapor-Degreasing Solvents Based on <bdit>normal</bdit>-Propyl Bromide and Technical Grade <bdit>normal</bdit>-Propyl Bromide
ASTM D 6368 : 2006 : R2012 Standard Specification for Vapor-Degreasing Solvents Based on <emph type="bdit">normal</emph>-Propyl Bromide and Technical Grade <emph type="bdit">normal</emph>-Propyl Bromide
ASTM D 3666 : 2006 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 2939 : 1998 Standard Test Methods for Emulsified Bitumens Used as Protective Coatings
ASTM D 3666 : 2004 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 3666 : 2005 : REV A Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 3666 : 2007 : REV A : EDT 1 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 3666 : 2009 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
ASTM D 3666 : 2002 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials

View more information
US$66.00
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.