• There are no items in your cart

ASTM D 5790 : 1995

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Test Method for Measurement of Purgeable Organic Compounds in Water by Capillary Column Gas Chromatography/Mass Spectrometry
Available format(s)

Hardcopy , PDF

Superseded date

11-11-2014

Language(s)

English

Published date

01-01-1995

CONTAINED IN VOL. 11.02, 2018 Defines the identification and simultaneous measurement of purgeable volatile organic compounds. It has been validated for treated drinking water, wastewater, and ground water.

1.1 This test method covers the identification and simultaneous measurement of purgeable volatile organic compounds. It has been validated for treated drinking water, wastewater, and ground water. This test method is not limited to these particular aqueous matrices; however, the applicability of this test method to other aqueous matrices must be demonstrated.

1.2 This test method is applicable to a wide range of organic compounds that have sufficiently high volatility and low water solubility to be efficiently removed from water samples using purge and trap procedures. Table 1 lists the compounds that have been validated for this test method. This test method is not limited to the compounds listed in Table 1; however, the applicability of the test method to other compounds must be demonstrated.

1.3 Analyte concentrations up to approximately 200 μg/L may be determined without dilution of the sample. Analytes that are inefficiently purged from water will not be detected when present at low concentrations, but they can be measured with acceptable accuracy and precision when present in sufficient amounts.

1.4 Analytes that are not separated chromatographically, but that have different mass spectra and noninterfering quantitation ions, can be identified and measured in the same calibration mixture or water sample. Analytes that have very similar mass spectra cannot be individually identified and measured in the same calibration mixture or water sample unless they have different retention times. Coeluting compounds with very similar mass spectra, such as structural isomers, must be reported as an isomeric group or pair. Two of the three isomeric xylenes are examples of structural isomers that may not be resolved on the capillary column, and if not, must be reported as an isomeric pair.

1.5 It is the responsibility of the user to ensure the validity of this test method for untested matrices.

1.6 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee
D 19
DocumentType
Test Method
Pages
55
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy

08/30168345 DC : DRAFT JULY 2008 BS ISO 15136-1 - DOWNHOLE EQUIPMENT FOR PETROLEUM AND NATURAL GAS INDUSTRIES - PROGRESSING CAVITY PUMP SYSTEMS FOR ARTIFICIAL LIFT - PART 1: PUMPS
API 11D2 : 2010 PROGRESSING CAVITY PUMP SYSTEMS FOR ARTIFICIAL LIFT - PUMPS
ASTM D 3694 : 1996 : R2017 Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents
ASTM D 3694 : 1996 Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents
I.S. EN ISO 15136-1:2009 PETROLEUM AND NATURAL GAS INDUSTRIES - PROGRESSING CAVITY PUMP SYSTEMS FOR ARTIFICIAL LIFT - PART 1: PUMPS
ASTM D 2777 : 2013 : REDLINE Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
ASTM D 7100 : 2011 : REDLINE Standard Test Method for Hydraulic Conductivity Compatibility Testing of Soils with Aqueous Solutions
ASTM D 3694 : 1996 : R2011 Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents
ASTM D 3694 : 1996 : R2004 Standard Practices for Preparation of Sample Containers and for Preservation of Organic Constituents
ASTM D 7100 : 2011 Standard Test Method for Hydraulic Conductivity Compatibility Testing of Soils with Aqueous Solutions
ASTM D 2777 : 2013 Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
ISO 15136-1:2009 Petroleum and natural gas industries — Progressing cavity pump systems for artificial lift — Part 1: Pumps
EN ISO 15136-1:2009 Petroleum and natural gas industries - Progressing cavity pump systems for artificial lift - Part 1: Pumps (ISO 15136-1:2009)
BS EN ISO 15136-1:2001 Downhole equipment for petroleum and natural gas industries. Progressing cavity pump systems for artificial lift Pumps

ASTM D 1129 : 2013 : REDLINE Standard Terminology Relating to Water
ASTM D 2777 : 2013 : REDLINE Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
CFR 40(PTS260-265) : JUL 2017 PROTECTION OF ENVIRONMENT - ENVIRONMENTAL PROTECTION AGENCY

View more information
US$117.00
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.