Standard Test Method for Low Level Sodium in High Purity Water by Graphite Furnace Atomic Absorption Spectroscopy

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

12-09-2022

Publisher

American Society for Testing and Materials

1.1This test method covers the determination of trace sodium in high purity water. The method range of concentration is 1 to 40 μg/L sodium. The analyst may extend the range once its applicability has been ascertained.

Note 1:It is necessary to perform replicate analysis and take an average to accurately determine values at the lower end of the stated range.

1.2This test method is a graphite furnace atomic absorption spectrophotometric method for the determination of trace sodium impurities in ultra high purity water.

1.3This test method has been used successfully with a high purity water matrix.2 It is the responsibility of the analyst to determine the suitability of the test method for other matrices.

1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 19
DocumentType	Test Method
Pages	5
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 6071 : 2014

ASTM D 1193 : 2006 : R2018	Standard Specification for Reagent Water
ASTM D 445 : 2021 : EDT 2	Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)

ASTM D 1129 : 2013 : R2020	Standard Terminology Relating to Water
ASTM D 1129 : 2013 : R2020 : EDT 2	Standard Terminology Relating to Water
ASTM D 1129 : 2013 : R2020 : EDT 1	Standard Terminology Relating to Water