ASTM D 6117 : 2023
Current
The latest, up-to-date edition.
Standard Test Methods for Mechanical Fasteners in Plastic Lumber and Shapes
Hardcopy , PDF
English
07-11-2023
1.1These test methods cover the evaluation of fastener use with “as manufactured” plastic lumber and shapes through the use of two different testing procedures.
1.2The test methods appear in the following order:
| Sections | ||
| Test Method A—Nail, Staple, or Screw Withdrawal Test | 4 to 13 | |
| Test Method B—Nail, Staple, or Screw Lateral Resistance Test | 14 to 22 |
1.3Plastic lumber and plastic shapes are currently made predominately from recycled plastics. However, these test methods would also be applicable to similar manufactured plastic products made from virgin resins where the product is non-homogeneous in the cross-section.
1.4The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information only.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1:There is no known ISO equivalent to this standard.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.