Standard Test Method for Time to Failure of Pressure Sensitive Articles Under Sustained Shear Loading

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

10-01-2020

Publisher

American Society for Testing and Materials

1.1This test method covers the ability of a pressure sensitive article (for example, tape, label, sticker, etc.) to remain adhered to a stainless steel panel under a constant load applied parallel to the bonding surface of the pressure sensitive article.

1.2Values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents, therefore, each system must be used independently without combining values in any way.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 10
DocumentType	Test Method
Pages	4
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 6463/D6463M : 2006 : R2012

ASTM E 177 : 1990 : REV A : R1996	Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM D 907 : 2015	Standard Terminology of Adhesives
ASTM E 691 : 2020	Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM E 691 : 2019 : EDT 1	Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM E 691 : 2023	Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM D 907 : 2015 : R2023	Standard Terminology of Adhesives
ASTM E 691 : 2022	Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM E 691 : 2009	Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM A 666 : 2015	Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
ASTM D 5750/D5750M : 1995	Standard Guide for Width and Length of Pressure-Sensitive Tape
ASTM E 691 : 2021	Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM A 666 : 2023	Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
ASTM E 171 : 1994 : R1998	Standard Specification for Standard Atmospheres for Conditioning and Testing Flexible Barrier Materials