Standard Test Method for the Continuous Measurement of Dissolved Ozone in Low Conductivity Water

Available format(s)

PDF

Language(s)

English

Published date

07-29-2016

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 11.01, 2017 Defines the on-line and in-line determination of dissolved ozone (DO[3]) in low conductivity water in the range from 0.001 mg/L to 5.0 mg/L DO[3] and conductivity < 100 [mu]S/cm, typical of pharmaceutical and microelectronics pure waters.

1.1This test method covers the on-line and in-line determination of dissolved ozone (DO₃) in low conductivity water in the range from 0.001 mg/L to 5.0 mg/L DO₃ and conductivity <100 μS/cm, typical of pharmaceutical and microelectronics pure waters. DO₃ is detected by correlating the response of a membrane-covered electrochemical sensor to the dissolved ozone concentration.

1.2This test method provides a more convenient means for continuous measurement than the colorimetric methods typically used for grab sample measurements.

1.3This test method has the advantage of high sensitivity as well as durability in the process environment and has few interferences.

1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee	D 19
DocumentType	Redline
Pages	5
PublisherName	American Society for Testing and Materials
Status	Current

ASTM D 1129 : 2013 : REDLINE	Standard Terminology Relating to Water
ASTM D 2777 : 2013 : REDLINE	Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water